Owner`s manual

3
No. L-A2-23507
REV 4 - 0712180900
TABLE OF CONTENTS
TABLE OF CONTENTS
Tools Recommended
The following tools and supplies may be needed to
assemble, install, and test the Real-Fyre
®
glass set:
1. Adjustable open-ended wrench 8" - 10"
2. Pipe wrench 8" - 10"
3. Pliers
4. Tefl on tape or pipe compound resistant to propane
gas
5. Small Phillips-head screwdriver & flat-head
screwdriver
6. Leak detector or soapy water solution & brush to test for
gas leaks
7. Work gloves
Other tools used for plumbing or gas appliance installation
may be necessary.
Important: To comply with certifi cations, listings, and building code acceptances, and for safe operation and
proper performance of this glass burner, use ONLY Peterson Real-Fyre
®
parts and accessories.
Use of other controls, parts, or accessories that are not approved for use with Real-Fyre
®
gas
burner systems is prohibited and will void all warranties, certifi cations, listings, and building code
approvals, and may cause property damage, personal injury, or loss of life.
PARTS LIST 4
MANUAL SERIES 26 CONTROL SYSTEM DETAIL 5
SERIES 01 CONTROL SYSTEM DETAIL 5
SERIES 11 CONTROL SYSTEM DETAIL 6
SERIES 15 CONTROL SYSTEM DETAIL 6
SERIES 16 CONTROL SYSTEM DETAIL 7
IMPORTANT INFORMATION 7
PRE-INSTALLATION REQUIREMENTS 8
FIREPLACE REQUIREMENTS 8
GLASS QUANTITY DETERMINATION 9
PRE-INSTALLATION AND FIREPLACE PREPARATION SAFETY 11
LOG SET NOTES PAGE 12
INSTALLATION 13
GLASS PLACEMENT 15
LIGHTING INSTRUCTIONS - SERIES 01 VALVE 17
LIGHTING INSTRUCTIONS - SERIES 11 VALVE 19
LIGHTING INSTRUCTIONS - SERIES 15 VALVE 21
LIGHTING INSTRUCTIONS - SERIES 16 VALVE 23
LIGHTING INSTRUCTIONS - SERIES 26 PILOT VALVE 25
AVAILABLE ACCESSORIES FOR THE GAS BURNER SYSTEM 26
CLEANING AND MAINTENANCE 28
OPTIONAL CONTROLS FOR YOUR REAL-FYRE
®
BURNER SYSTEM 29
TROUBLESHOOTING YOUR GLASS BURNER 30
WARRANTY 32
This appliance may be installed in
an aftermarket, permanently located,
manufactured (mobile) home where not
prohibited by local codes. Installation of
appliances designed for manufactured
homes or mobile homes must conform
with Manufactured Home Construction
and Safety Standard, Title 24 CFR, Part
3280 in the U.S.; or with CAN/CSA Z240
MH in Canada; or with ANSI/NCSBCS
A225.1/NFPA 501A, Manufactured Home
Installations Standard when such a
standard is not applicable.