Owner`s manual
8
LOG PLACEMENT (cont.)
Log placement is very important for the proper operation of the Real-Fyre
®
gas log set. Although you have
some fl exibility in the log arrangement, it is necessary to follow the LOG PLACEMENT instructions carefully to
fully enjoy your log set. Follow the steps below, referring
to Fig. 8-1 through Fig. 8-5.
1. The second-longest log, the rear log, is placed on
the rear of the grate with the bark of the log facing
forward (Fig. 8-1). Center the log left to right (Fig.
8-5, #1).
2. The longest log, the front log, is placed on the front
of the grate with the bark facing forward. Center left
to right (Fig. 8-2, #2). NOTE: Be sure to maintain a
space between the front and rear logs (Fig. 8-1).
3. Top logs should be stacked diagonally, with the
largest at the bottom (Fig. 8-3, #3 & 4), and with
spaces between the logs so that the fl ames are not choked off. Place the smaller logs diagonally across
the larger ones (see Fig. 8-4, #5 & #6). The top logs may be moved to achieve desired fl ame pattern.
Some carbon buildup (sooting) may occur where the fl ames impinge on the logs and should not be a
concern unless excessive. If sooting is excessive, rearrange the top logs to reduce fl ame impingement.
Examples of log stacks are shown below.
Note: Although log styles may differ in pattern or shape ( Fig. 8-6), layout is essentially the same. Adequate
spacing between the logs is NECESSARY and MUST be maintained for best performance.
Fig. 8-5
Alternative examples of log layout (Split Oak
set shown). Note the space between the logs.
STEP 1. Place the second-longest
log to the rear.
2
5
6
Knotholes go to the front
or back as desired.
1
Fig. 8-2
Fig. 8-3
Fig. 8-4
Note: 24" Golden Oak (R-24) shown
Fig. 8-6 - Recommended log patterns
Woodland
Oak
Split Oak
Designer Plus
Royal English
Oak Designer
3
4
Fig. 8-1
Rear
bottom
log
Front
bottom
log
Grate
Burner pan
Stabilizer
clips
Granules
Glowing embers
(on top of granules)
Back wall
of fireplace
Stabilizer clip
fits over rear
edge of
burner pan
NOTE: LOGS SUPPLIED SEPARATELY.
STEP 2. Place the longest
log at the front.
STEP 3. Place the largest top logs
across the bottom logs.
(Note the gaps between the logs.)
STEP 3 (cont.) Place the smaller top logs
across the other logs.
REV 0 - 1407291335
L-A2-293