Owner`s manual

L-A2-20707REV 5 - 0705071310

LIGHTING INSTRUCTIONS

If your gas log set is operated by the ﬁ replace valve:

1. Lay a lighted long-stem match on the surface of the embers near the gas inlet (do not hold

the match in your hand) or use a lighted long-necked butane lighter (Fig. 9-1).

2. Slowly turn the ﬁ replace remote valve to the ON position. Your log set should light.

3. If the log set does not light before the match goes out,

immediately turn the valve to the OFF position.

4. Wait approximately ﬁ ve (5) minutes to clear out any

gas, and repeat steps 1-3 above.

5. If your log set fails to light again, turn the valve to

the OFF position and contact your dealer or gas

supplier.

6. To extinguish your gas log set, turn the valve to

the OFF position. Be sure the valve is turned fully

off to avoid any gas leakage.

If your gas log set is operated by a Peterson manual safety pilot system (SPK Series) or a

Peterson remote safety pilot system (APK Series):

1. Carefully follow the lighting instructions supplied with your Peterson pilot system for the steps

to ignite the burner.

Before operating your gas log set:

1. Be sure your ﬁ replace is free from ﬂ ammable liquids or combustible materials.

2. Be sure your damper is open.

3. Smell all around the gas log set for the odor of escaping gas. IF YOU SMELL GAS, FOLLOW THE

INSTRUCTIONS ON P. 1.

Fig. 9-1

Apply match - then turn on gas

1. When your log set is burning, your ﬁ replace damper must be fully open.

2. A fireplace screen must be in place when the log set is burning and, unless other

provisions for combustion air are provided, the screen shall have an opening(s)

for introduction of combustion air.

3. When a glass fireplace enclosure (door) is used, operate your gas log set with the

glass doors open.

4. Periodically check the log layout and adjust the top logs if sooting becomes

excessive.

IMPORTANT OPERATING INFORMATION

Important: Adequate log spacing must be maintained for best performance.