Owner`s manual

2
L-A2-207
REV 5 - 1011041445
TABLE OF CONTENTS
TABLE OF CONTENTS
Tools Recommended
The following tools and supplies may be needed to
assemble, install, and test the Real-Fyre
®
gas log set:
1. Adjustable open-ended wrench 8" - 10"
2. Pipe wrench 8" - 10"
3. Pliers
4. Tefl on tape or pipe compound resistant to propane gas
5. Small Phillips-head screwdriver & fl at-head screwdriver
6. Leak detector or soapy water solution & brush to test
for gas leaks
7. Work gloves (for hot logs only)
Other tools used for plumbing or gas appliance installation
may be necessary.
Charred Series
Charred Oak (CHD)
Charred Split (CHS)
Charred Royal (CHB)
Available Log Styles:
Designer Series
Golden Oak Designer Plus (RDP)
Split Oak (S)
Split Oak Designer Plus (SDP)
Woodland Oak (WO)
Emberwood Designer (EXD)
Royal English Oak Designer (BD)
Heritage Designer (HD)
White Birch (W)
Golden Oak Designer (RD6)
Classic Series
Golden Oak (R)
Post Oak (PO)
Emberwood (E)
Royal English Oak (B)
Mountain Oak (K)
Twisted Pine (C)
WARNING
Improper installation, adjustment, alteration, service,
or maintenance can cause injury or property damage.
Refer to this manual. For assistance or additional
information, consult a qualified installer, service
agency, or the gas supplier.
FOR YOUR SAFETY
Do not store or use gasoline or other fl ammable
vapors and liquids in the vicinity of this or any other
appliance.
PARTS LIST 3
IMPORTANT INFORMATION 4
FIREPLACE REQUIREMENTS 4
INSTALLATION 5
INSTALLING THE BURNER 5
GRANULE, EMBER, AND GRA
TE PLACEMENT 6
LOG PLACEMENT 6
OPTIONAL CHARRED SERIES INSTALLATION 8
LIGHTING INSTRUCTIONS 9
MAINTENANCE & SERVICE 10
OPTIONAL CONTROLS 10
OPTIONAL PETERSON VALVES & SAFETY PILOT KITS* 11
TROUBLESHOOTING YOUR GAS LOG SET 12
WARRANTY 14