Owner`s manual

13
L-A2-081
Rev 2 - 1401130750
LIGHTING THE BURNER
1. Ensure the pilot is burning. Turn the gas control knob
counterclockwise to ON (Fig. 13-1 or Fig. 13-2) to ignite
the burner. The valve will open and the burner will light.
Note: When the valve is installed on the right side
of the burner (i.e. on pan models), refer to Fig.
13-1 for knob orientation. When it is installed
on the left side of the burner (i.e. G31 models),
refer to Fig. 13-2.
Note: The ignition sequence will take approximately 5
seconds.
WARNING: If the burner fails to light within 5 seconds,
turn the control knob clockwise to
PILOT. Allow five (5) minutes for any
gas in the unit to dissipate, then repeat
step 2 above. IF YOU SMELL GAS, SEE
STEP B AT BEGINNING OF LIGHTING
INSTRUCTIONS.
If the burner fails to light after several tries, push in the
control knob slightly and turn clockwise to OFF, and contact
a qualifi ed professional service technician.
PILOT BURNER CHECK/ADJUSTMENT
With the pilot burner lit and the control knob in the pilot
position, check the pilot system for proper fl ame size and
appearance (see Fig. 13-3). The pilot adjustment screw is
located on the front of the gas valve (see Fig. 13-3). Using
a small fl at head screwdriver, adjust the pilot screw to
properly size the fl ames. Turning the screw clockwise will
lower the fl ames, and turning it counterclockwise will raise
them. Be careful not to back the screw out of its threads.
The pilot fl ame should be a quiet, soft blue fl ame with yellow
tipping that encircles the thermocouple tip.
SHUTTING DOWN
To extinguish the main burner (pilot will remain lit):
Turn the control knob clockwise to PILOT.
To extinguish the pilot:
push in the control knob slightly and turn clockwise to OFF.
ON
OFF
ON
PILOT
OFF
ON
PILOT
OFF
ON
PILOT
Fig. 13-1 Control knob detail (ON) - pan models
For Manual
Lighting, turn knob
counterclockwise to
ON position.
LIGHTING INSTRUCTIONS (Cont.)
Fig. 13-2 Control knob detail (ON) - G31 models
For Manual
Lighting, turn knob
counterclockwise to
ON position.
OFF
ON
PILOT
OFF
ON
PILOT
OFF
ON
PILOT
ON
Fig. 13-3 Pilot adjustment detail
Pilot adjustment screw
Thermocouple
PILOT VALVE