Owner`s manual

12
L-A2-081
Rev 2 - 1401130750
PILOT
OFF
OFF
ON
PILOT
OFF
ON
PILOT
OFF
ON
PILOT
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fi re or explosion may result causing property
damage, personal injury or loss of life.
A. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in
or turn by hand, don't try to repair it. Call a qualifi ed professional service technician. Excessive force or
attempted repair may result in fi re or explosion.
B. BEFORE OPERATING, smell all around the appliance area for gas. Be sure to smell next to the fl oor
because some gas is heavier than air and will settle on the fl oor.
WHAT TO DO IF YOU SMELL GAS
• Do not light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
If you cannot reach your gas supplier, call the fi re department.
C. The burner system has a pilot that can be lit by hand using a match or long-necked lighter. When lighting
the pilot, follow these instructions exactly.
D. Do not use this appliance if any part has been under water. Immediately call a qualifi ed service technician
to inspect the appliance and to replace any part of the control system and any gas control which has been
under water. Attempted operation may result in fi re or explosion resulting in property damage, personal
injury or loss of life.
LIGHTING THE PILOT
1. Locate the valve on the side of the unit. Push in the
gas control knob slightly and turn clockwise to OFF
(Fig. 12-1 or Fig. 12-2).
Note: The control knob cannot be turned from PILOT
to OFF unless the knob is pushed in slightly. Do
not force.
Note: When the valve is installed on the right side
of the burner (i.e. on pan models), refer to Fig.
12-1 for knob orientation. When it is installed
on the left side of the burner (i.e. G31 models),
refer to Fig. 12-2.
Allow fi ve (5) minutes for any gas in the unit to dissipate.
IF YOU SMELL GAS, SEE STEP B ABOVE. If you don’t
smell gas, go on to step 2.
2. Turn the control knob counterclockwise to PILOT
(Fig. 12-1 or Fig. 12-2). Push the control knob fi rmly
and fully in and hold. Hold a long fi replace match
or lighter near the thermocouple to light the pilot.
Continue to hold the control knob in for approximately
60 seconds after the pilot is lit, then release the knob.
The pilot will remain lit.
WARNING: If the pilot fails to light repeat steps 1
and 2.
If the pilot fails to light after several tries, turn the control
knob to OFF and contact a qualifi ed professional service
technician.
Fig. 12-1 Control knob detail - pan models
1. Turn knob
clockwise to OFF
prior to lighting
the pilot.
2. Turn knob
counterclockwise to
PILOT position. With
match ready, press
knob in and hold for
60 seconds while
lighting pilot.
LIGHTING INSTRUCTIONS
Fig. 12-1 Control knob detail - G31 models
1. Turn knob
clockwise to OFF
prior to lighting
the pilot.
2. Turn knob
counterclockwise to
PILOT position. With
match ready, press
knob in and hold for
60 seconds while
lighting pilot.
OFF
ON
PILOT
OFF
ON
PILOT
OFF
ON
PILOT
OFF
ON
PILOT
OFF
ON
PILOT
OFF
ON
PILOT
OFF PILOT