Owner`s manual

L-A2-081

Rev 2 - 1401130750

INSTALLATION - G31 MODELS (Cont.)

INSTALL PILOT ASSEMBLY TO BURNER

CAUTION: Use only the pilot assembly pre-assembled

with this kit. Never substitute with an existing

pilot.

CAUTION: Do not kink or damage the pilot gas supply

line and thermocouple lead.

1. The pilot assembly comes with a pilot bracket installed.

Remove the four screws and bracket on the assembly

and DISCARD.

2. The pilot assembly is to be located on the upper left

side of the burner. Route the pilot gas supply line and

thermocouple lead down through the holes in the

burner until the pilot is in place. Use the two burner

screws (pre-installed onto the burner) to fasten the

pilot assembly in place. See Fig. 10-1.

3. Carefully route the pilot gas supply line and

thermocouple lead to the valve and reconnect using

the adjustable crescent wrench (see Fig. 10-2).

Important: The pilot gas supply line and thermocouple

lead must be bent in an ideal manner

to prevent damage / unsafe operation.

Maintain this orientation at all times.

WARNING: Keep the pilot assembly clear at all

times. Never cover any part of the pilot

assembly.

Fig. 10-1 Install pilot assembly

Fig. 10-2 Route and connect line / lead to valve

Secure