Owner`s manual

INSTALLATION (cont.)

6. Be sure gas to the ﬁ replace is off. Remove the adapter

that is loosely connected to the open end of the ﬂ ex

connector. Attach the adapter to the gas-supply stub

using a pipe compound resistant to all gases. Tighten

securely. Then attach the open end of the ﬂ ex connector

to the adapter. Tighten securely. Ensure the pan rests

level on the ﬁ replace ﬂ oor after connection. Adjust the

pan if necessary.

7. LEAK TEST: Be sure the control valve is in the OFF

position. Turn on the ﬁ replace gas supply, and test at

all connections for leaks using the appropriate soapy

water solution. If bubbles appear, a leak is present.

Turn off the gas and tighten at all connections. Repeat

until no leaks are present. If a leak persists, turn off

the gas supply and contact the local gas company or

dealer. NEVER USE A FLAME TO CHECK FOR LEAKS.

Turn off the gas supply prior to proceeding.

Important: Heatshields must be in place during operation of the burner system. Overheating of the valve

will cause shut down of the burner system or other operating problems.

Fig. 8-1

Ignitor

Safety (ON/OFF) valve

To gas supply

Thermocouple wire

Spark

wire

Burner pan

Thermocouple

(under screen)

Regulator

Heat shield

(removed)