Owner`s manual

25
PILOT BURNER ADJUSTMENT
The pilot burner is preset at the factory and should
normally not require any adjustment. However, should
adjustment be necessary, the following steps should
be taken:
With the pilot burner lit and the control knob in
the pilot position, remove the heatshield covers.
Adjust the screw located on the control valve (see
Fig. 25-1). Using a screwdriver, turn the pilot
adjustment screw slowly clockwise to reduce the
fl ame, or counterclockwise to increase the fl ame. The
adjustment screw can be turned so that the pilot fl ame
is completely extinguished. The pilot fl ame should be a
quiet soft blue fl ame with yellow tipping that encircles
the thermocouple tip.
Replace the heatshield covers. Turn the control knob
to the ON position to assure proper ignition of the
log set.
Fig. 25-1
PILOT
ADJUSTMENT
Example of
burner pilot
fl ame with
thermopile
Example of
burner pilot
fl ame with
thermocouple
Pilot adjustment