Owner`s manual

ManualsBrandsR.H. Peterson ManualsBurnerG45-2 SEE-THRU Series

1. STOP! Read the safety information above.

2. Turn off any electrical appliance used with the

burner system.

3. Verify the switch (marked I = IGNITE; O = OFF)

located on the front of the switch box is set to

"O" (OFF). Do not force.

4. Wait ﬁ ve (5) minutes to clear out any gas. If

you then smell gas, STOP! Follow the safety

information above. If you don't smell gas, go to

the next step.

5. Depress the "I" (IGNITE) switch on the front of

the switch box. This transmits a rapid series of

sparks at the pilot head. These sparks cease

when the pilot ﬂ ame is lit and stable. The pilot is

located at the rear right corner of the burner.

After a short time, the pilot will light the main

burner.

CAUTION: IF THE GAS SET DOES NOT

IGNITE WITHIN 20 SECONDS,

STOP, PRESS "O" (OFF), WAIT

FIVE (5) MINUTES, THEN REPEAT

STEPS 3-6.

• The pilot should remain lit. If it goes out, repeat

steps 3 through 6.

• If the pilot will not stay lit after several tries, turn the

switch box to "O" (OFF) (Fig. 21-1) and call your

service technician or gas supplier.

6. To turn the set OFF, press the "O" (OFF) switch

on the front of the switch box. The gas ﬂ ow will

cease, and all ﬂ ames will go out.

If this unit was shipped with a remote, or if a

remote system was installed later, read and follow

the separate remote instructions to operate the

burner remotely.

1. Put the switch in the OFF position. The burner will extinguish, and the pilot will go out.

1. LIGHTING - Verify the switch (marked I = IGNITE; O =

OFF) located on front of the switch box is set to O. Wait

ﬁ ve (5) minutes for the gas to clear out.

LIGHTING INSTRUCTIONS - SERIES 01 VALVE

WARNING: If you do not follow these instructions exactly, a ﬁ re or explosion may

result, causing property damage, personal injury, or loss of life.

BEFORE LIGHTING,

smell all around the gas burner area for gas. Be sure to smell next to the ﬂ oor,

because some gas is heavier than air and will settle on the ﬂ oor. IF YOU SMELL GAS, FOLLOW THE

INSTRUCTIONS ON P. 1.

Fig. 21-1

1. Press O (OFF) when

complete shutdown

is desired.

2. Press I (IGNITE)

After a series of rapid

sparks, the pilot will

light. When the pilot is

stable, the main burner

will ignite.

SHUT-OFF INSTRUCTIONS - SERIES 01 VALVE

FOR YOUR SAFETY, READ BEFORE LIGHTING