Owner`s manual

15
The log set is purchased and packaged separately. Charred Split Oak log set (CHS) shown here. Styles and sizes
will vary depending upon the log set ordered. If the log set ordered includes placement instructions; follow those
instructions. When ordering replacement parts; be sure to indicate your log set and burner model.
LOG PLACEMENT
Note: The charred sections should be over the
opening between the front and rear logs
(Fig. 15-4).
Attach the ember bed (Part No. CHD-01) to the burner
by slipping it onto the back edge (center left to right)
with the perforated section facing towards the back
fi replace wall (Fig. 15-1).
Cover the surface of the ember bed with the glowing
embers supplied with the Charred series log set, as
shown in Fig. 15-2.
Note: For best glowing performance, they should
be applied evenly and pulled slightly apart
so the fi bers are somewhat loose.
Important: It is not necessary to pile the entire
bag of the glowing embers. More
glowing embers may be added after
completion of the entire installation.
Fig. 15-1
Part No.
CHD-01
Fig. 15-2
Fig. 15-3
LOG #1B
LOG #2
LOG #1A
Fig. 15-6
MAINTAIN A SPACE IN THE CENTER OF
THE LOGS AT ALL TIMES
Fig. 15-4
LOG #3
LOG #4
Fig. 15-5
CHARRED LOG PLACEMENT
SCREEN AND EMBERS PLACEMENT
Ember bed
Step 1.
Place the long bottom rear log (log #2) on the
back of the grates with the fl at, featureless
side facing the rear of the fi replace. Slide it
forward to touch the log locator.
Step 2.
The two sections of the front log (logs #1A &
1B) are placed on the front of the grate with
the charred sections facing each other and
approximately 1" apart at the top (Fig. 15-3).
Slide them back against the log locators.
Note: The log locators ensure that adequate
space between front and rear logs are
maintained for a cleaner burn.
Step 3.
Place the two curved logs (logs #3 & #4) so
that one end rests on each front log section
(logs #1A & 1B) and the other end rests on
the rear log (log #2).
LOG #6
LOG
#5
Step 4.
Place the small top charred logs (logs #5 &
#6) so they rest over the charred sections
of the front bottom log sections (logs # 1A
& 1B) and on the two curved logs (logs #3
& #4) (Fig. 15-5).
Place the curved top charred log (log #7)
to rest on the two top logs at rear, but not
encroaching into the space between rear
and front logs (Fig. 15-6).
Step 5.
Note: The additional top log (log #7) is not
available with 18" log sets.
Glowing embers
Part No.
EM-4
LOG #7