Owner`s manual

14
LOG PLACEMENT
The log set is purchased and packaged separately. Woodland Oak log set (WO) shown here. Styles and sizes
will vary depending upon the log set ordered. If the log set ordered includes placement instructions; follow those
instructions. When ordering replacement parts; be sure to indicate your log set and burner model.
Note: For Charred series, see the following section.
Proper log placement is important to ensure proper performance of the Real-Fyre
®
gas log set. Be sure to follow
the LOG PLACEMENT INSTRUCTIONS carefully. Three optional log placement patterns, an exclusive feature of
the log set, are explained below.
FOR ALL OPTIONS
Fig. 14-4
Option 2
Steps 2 & 3
4
3
6
5
CAUTION: Burn hazard. Logs will remain hot for some time after use. You must maintain the log
layout as shown to ensure proper operation of the log set. If you need to reposition
any log to maintain the proper layout, use heat-resistant gloves or allow logs adequate
time to cool before handling.
Fig. 14-5 Op-
tion 3
Steps 2 & 3
4
6
5
3
Option 1
Step 2
Fig. 14-2
Option 1
Step 3
Fig. 14-3
6
5
3
4
Fig. 14-1
2
1
24" Woodland Oak (WO) log set shown.
Step 1:
Place the rear bottom log (Log #1) on the back of the grate (Fig. 14-1),
and slide it forward against the log locators. Place the front log (Log #2)
on the front of the grate and slide it back against the log locators. The
log locators ensure that adequate space between the logs is maintained
for a cleaner burn.
OPTION 1
Step 2:
Place the middle log (Log #4) to rest on the front and rear bottom logs, as shown in Fig. 14-2. Place Log #3 so it
rests on Log #4 and the front log, as shown in Fig. 14-2. Ensure they are placed across the space between the logs.
Place the top logs (Logs #5 & #6) as sho
wn in Fig. 14-3, with Log #5 resting on Log #3 and the front log, and
Log #6 resting on the rear log and Log #4.
Step 3:
OPTION 2
Step 2:
Place the middle logs parallel, as shown in Fig. 14-4. Log #3 is placed with one end on the front log, and the
other end resting on Log #4.
Step 3:
Place Log #5 resting on the front log and the left middle log, and Log #6 resting on the rear log and the r
ight
middle log, as shown in Fig. 14-4.
OPTION 3
Place the middle logs (Logs #3 & #4) so they are parallel, resting on the front and rear logs across the space,
as shown in Fig. 14-5.
Step 2:
Step 3:
Place top Logs #5 & #6 so the
y are parallel and rest across Logs #3 & #4, as shown in Fig. 14-5.