Owner`s manual

REV 0 - 1012011423

L-A2-298

MAINTENANCE

Once installed and operating properly, the Real-

Fyre

gas log set requires very little maintenance.

You should inspect the log set and control annually

for the following:

1. Excessive sooting - Some sooting of the log set

is normal and adds to the appearance of burned

wood. If sooting accumulates, you may brush the

soot off with a stiff brush. Do not use water or

soot cleaners to clean off the soot.

2. Settling of glowing embers and granules -

Moisture may cause the granules and glowing

embers in the burner pan to settle and affect

the burn. Using a screwdriver or ﬂ at blade knife,

carefully stir the granules and embers, loosening

the materials.

3. Debris around the control - Inspect the control

to be sure it is free of any dirt or debris.

SERVICE

While some minor service conditions may

be handled by the owner of the log set, it is

recommended that a qualiﬁ ed service technician be

called to service the gas log set and control should

service be required. The TROUBLESHOOTING

section of these instructions serves as a guide for

ensuring optimum performance of the gas log set.

FLAME DESCRIPTION

Observe the ﬂ ames. The main burner ﬂ ames should

be blue at the base and a combination of blue/

yellow at the body and at the tips. They should be

5" to 8" above the logs, with the center ﬂ ame being

the tallest (see cover photo). Flames in the ember

burner should be

" above the embers.

To adjust the ﬂ ame pattern, take a long blade screwdriver or similar tool and stir the granules until the desired

pattern is achieved. DO NOT REMOVE GRANULES FROM THE BURNER PAN

TECHNICAL DATA AND SPECIFICATION INFORMATION