Owner`s manual

ManualsBrandsR.H. Peterson ManualsBurnerG45-2 SEE-THRU Series

REV 0 - 1012011423

L-A2-298

Robert H. Peterson Co. • 14724 East Proctor Avenue • City of Industry, CA 91746

Owner’s

Manual

Important: Read this manual carefully before starting installation of the log set.

INSTALLER: Leave this manual with the appliance.

CONSUMER: Retain this manual for future reference.

This appliance is designed as an attended

appliance. Adults must be present when the

unit is operating. DO NOT leave this unit burning

when unattended. If this product is left burning

unattended it may cause damage or serious

injury.

WARNING

Improper installation, adjustment, alteration,

service, or maintenance can cause injury or

property damage. Read the installation, operating

and maintenance instructions thoroughly before

installing or servicing this equipment.

Do not store or use gasoline or other

ﬂ ammable vapors and liquids in the vicinity

of this or any other appliance.

An LP-cylinder shall not be stored in the

vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS:

• Do not try to light any appliance.

• Do not touch any electrical switch; do

not use any phone in the building.

• Immediately call the gas supplier from

a neighbor’s phone and follow the gas

supplier’s instructions.

• If you cannot reach the gas supplier,

call the ﬁ re department.

WARNING

If the information in this manual is not followed

exactly, a ﬁ re or explosion may result, causing

property damage, personal injury, or loss of life.

Installation and service must be performed

by an NFI Certiﬁ ed or other qualiﬁ ed

professional installer, service agency, or

the gas supplier.

Burner systems:

G45-2-16/19(N,P)-SS

G45-2-18/20(N,P)-SS

G45-2-24(N,P)-SS

G45-2-30(N,P)-SS

G45-2-36(N,P)-SS

G45-2-42(N,P)-SS

G45-2-48(N,P)-SS

G45-2-60(N,P)-SS

Unregulated burner

system for use with

propane or natural gas

G45-2 STAINLESS STEEL BURNER FOR INDOOR OR OUTDOOR USE

CODE AND SUPPLY REQUIREMENTS

This outdoor burner must be installed in accordance

with local codes and ordinances, or in the absence of

local codes, with the latest National Fuel Gas Code,

ANSI Z223.1.

FOR INSTALLATION IN

SEE-THRU SOLID-FUEL

BURNING FIREPLACES

Summary of content (12 pages)

PAGE 1
Owner’s Manual Burner systems: G45-2-16/19(N,P)-SS G45-2-18/20(N,P)-SS G45-2-24(N,P)-SS G45-2-30(N,P)-SS G45-2-36(N,P)-SS G45-2-42(N,P)-SS G45-2-48(N,P)-SS G45-2-60(N,P)-SS FOR INSTALLATION IN SEE-THRU SOLID-FUEL BURNING FIREPLACES Unregulated burner system for use with propane or natural gas G45-2 STAINLESS STEEL BURNER FOR INDOOR OR OUTDOOR USE Important: Read this manual carefully before starting installation of the log set.
PAGE 2
TABLE OF CONTENTS SAFETY INFORMATION PARTS LIST BEFORE YOU BEGIN - IMPORTANT INFORMATION INSTALLING THE DAMPER CLAMP INSTALLATION LOG PLACEMENT OPERATING THE LOG SET - LIGHTING AND EXTINGUISHING TECHNICAL DATA AND SPECIFICATION INFORMATION TROUBLESHOOTING THE GAS LOG SET WARRANTY 2 3 4 5 5 7 8 9 10 12 SAFETY INFORMATION 1. Children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition. 2.
PAGE 3
PARTS LIST Before beginning installation, be sure the gas log set is complete by comparing its contents with this PARTS LIST. The Golden Oak log set is listed and illustrated. The parts may differ depending upon the log style and size of the set. Be sure you know the model number and size of your set when ordering replacement or optional parts and accessories. 9 6 4 Replacement parts can be ordered from your local dealer. 10 Glowing embers 5 3 2 11 Granules 1 7 12 13 13 8 ITEM# DESCRIPTION 1.
PAGE 4
BEFORE YOU BEGIN - IMPORTANT INFORMATION Before You Begin, review the information and safeguards below about the installation and operation of the RealFyre® gas log set. Fireplace dimensions Fig. 4-1 Check to be sure that the fireplace meets the venting and construction requirements for the installation of the Real-Fyre® gas log set. THIS BURNER IS DESIGNED FOR USE WITH PROPANE OR NATURAL GAS.
PAGE 5
INSTALLING THE DAMPER CLAMP The damper clamp with hex bolt (Fig. 5-1) is provided as a means to prevent full closure of the damper blade. The clamp is easily attached to most damper blades with pliers or a wrench, and must be permanently installed. The clamp is designed to prevent accidental closure of the damper when installed as illustrated (Fig. 5-2 and Fig. 5-3).
PAGE 6
INSTALLATION (cont.) 7. LEAK TEST: Turn on the fireplace gas supply, and test at all connections for leaks using the appropriate soapy water solution. If bubbles appear, a leak is present. Turn off the gas and tighten at all connections. Repeat until no leaks are present. If a leak persists, turn off the gas supply and contact the local gas company or dealer. NEVER USE A FLAME TO CHECK FOR LEAKS. Fig.
PAGE 7
LOG PLACEMENT 1. Log placement is very important for the proper operation and performance of the Real-Fyre® gas log set. Although you have some flexibility in the log arrangement, it is necessary to follow the log placement instructions carefully to fully enjoy the log set. Fig. 7-1 2. Place the bottom logs on the grate. The log locators ensure that adequate space between the logs is maintained for a clean burn (Fig. 7-1). 3.
PAGE 8
OPERATING THE LOG SET - LIGHTING AND EXTINGUISHING FOR YOUR SAFETY, READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result, causing property damage, personal injury, or loss of life. C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it. Call a qualified service technician. Force or attempted repair may result in fire or explosion. A.
PAGE 9
TECHNICAL DATA AND SPECIFICATION INFORMATION MAINTENANCE SERVICE Once installed and operating properly, the RealFyre® gas log set requires very little maintenance. You should inspect the log set and control annually for the following: 1. Excessive sooting - Some sooting of the log set is normal and adds to the appearance of burned wood. If sooting accumulates, you may brush the soot off with a stiff brush. Do not use water or soot cleaners to clean off the soot.
PAGE 10
TROUBLESHOOTING THE GAS LOG SET SYMPTOM 1. Excessive smoking and sooting CAUSE A. Poor draft or down draft Note: Like burning natural firewood, the RealFyre® gas log set is designed to burn with a yellow smoky flame. Some sooting is common and desirable. B. Improper set for gas used C. Damper closed D. Set is positioned too close to the front of the firebox E. Improper log placement 2. Low flame F. Air mixer on propane set is closed A. Incorrect log set size for burner system B.
PAGE 11
TROUBLESHOOTING THE GAS LOG SET (cont.) SYMPTOM 3. Uneven flame distribution (Lower at one end of the burner) 4. Flame backing out of air mixer (propane) REV 0 - 1012011423 CAUSE A. Clogged or blocked portholes A. B. Insufficient gas pressure and/or supply C. Granules may be packed down too tightly or not evenly B. D. Auxiliary shut-off valve partially closed D. E. Valve not fully open A. Clogged or blocked portholes E. A. B. Insufficient gas pressure and/or supply C.
PAGE 12
WARRANTY PETERSON VENTED GAS LOG SETS LIMITED WARRANTY All Peterson gas logs are WARRANTED for as long as you own them (lifetime). All Peterson burner assemblies are WARRANTED for TEN (10) YEARS. SPK-26 controls are covered by a THREE (3) YEAR “All Parts” Warranty. All other Peterson valves, pilots, and controls are covered by a ONE (1) YEAR Limited Warranty (excluding batteries).