Owner`s manual

9
WARNING: Failure to position the parts in
accordance with these diagrams or
failure to use only parts specifi cally
approved with this appliance may
result in property damage or
personal injury.
Peterson Real-Fyre
®
gas logs must be installed
only in a wood-burning fi replace with minimum
venting requirements met (see Technical Data
Table under GENERAL INFORMATION) and with
the damper fully open. Check PARTS LIST to be
sure all parts are included. For safe operation and
proper performance, use only Robert H. Peterson
parts and accessories. Gas-supply pipe must be
1
/
2
". A larger line (
3
/
4
") may be required if gas line
is longer than 20'.
REFER TO PARTS LIST WHEN FOLLOWING
THESE INSTRUCTIONS.
Be sure gas to the fireplace is off when
installing the log set.
1. Remove the grate (Item #6) from the carton
and attach the log locators (Item #4) at
the middle of the grate, positioned per the
illustrations of the log option chosen.
Note: Do not place the grate on the burner
assembly until you have completed
the gas connection and media (sand,
vermiculite, or embers) placement.
2. Place the burner assembly into the fi replace
and center it.
3. Connect the gas connector kit (PARTS LIST,
Item #11) to the nipple on the regulator and
gas supply of the fi replace and tighten with
a wrench.
4. Turn on the gas to the fi replace and test for
leaks at all connections with a soapy water
solution. If bubbles appear, a leak is present.
Turn off the gas and tighten all connections,
turn on the gas and repeat the leak test.
Repeat until no leaks are detected. Never
use a fl ame to check for leaks.
SAND OR VERMICULITE PLACEMENT
1. With the burner off, fill the burner pans
completely with sand or vermiculite (PARTS
LIST, Item #10). Slope the media at the same
angle as the burner pan (see Fig. 9-1).
EMBER PLACEMENT
1. Sprinkle embers (PARTS LIST, Item #9)
lightly and evenly over the entire surface of
the granules, making sure that the pilot is not
covered (Fig. 9-2). Center the grate over
the burner pans (Fig. 9-3).
2. Place the bottom logs on the grate. The
log locators (PARTS LIST, Item #4) ensure
that adequate space between the logs is
maintained for a clean burn (Fig. 9-3).
3. Position the middle logs per the log option
chosen.
4. Position the top logs per the log option
chosen (Fig. 9-4).
INSTALLATION
(Sand is for natural units only, vermiculite
is for propane units only)
Fig. 9-1
Fig. 9-4
Fig. 9-2
Fig. 9-3