Owner`s manual

LIGHTING INSTRUCTIONS - MANUAL VALVE

The Real-Fyre

burner system has a pilot that can be lit by hand using a match or lighter. When lighting the

pilot, follow these instructions exactly.

BEFORE LIGHTING, smell all around the burner area for gas. Be sure to smell next to the ﬂ oor, as some gas

is heavier than air and will settle on the ﬂ oor. IF YOU SMELL GAS, FOLLOW THE INSTRUCTIONS ON P. 1.

Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn

by hand, don't try to repair it. Call a qualiﬁ ed professional service technician. Force or attempted repair may

result in ﬁ re or explosion.

Do not use this appliance if any part has been underwater. Immediately call for a qualiﬁ ed professional

service technician to inspect the appliance and to replace any part of the control system and any gas control

that has been underwater.

FOR YOUR SAFETY, READ BEFORE LIGHTING

LIGHTING THE LOG SET

Important: Keep the gas log burner area free from combustible materials, gasoline, and other ﬂ ammable

vapors.

1. Be sure chimney damper is fully open.

2. To light the log set with the ﬁ replace valve, lay a lighted match on the surface of the burner embers

(granules) near the gas inlet (Fig.

11-1). DO NOT HOLD THE MATCH IN YOUR HAND. Turn on the gas

slowly. Burner should light.

3. If a safety pilot is used, see the safety pilot instruction sheet.

4. If an APK system is used, see APK instructions.

WARNING

If you do not follow these instructions exactly, a ﬁ re or explosion may result, causing property

damage, personal injury, or loss of life.

Fig. 11-1

Observe the ﬂ ames. The main burner ﬂ ames should be blue at the base and a combination of blue/yellow

at the body and at the tips. They should be 5" to 8" above the logs, with the center ﬂ ame being the tallest

(see cover photo). Front ﬂ ames in the ember burner should be

" above the embers.