Owner`s manual

ManualsBrandsR.H. Peterson ManualsBurnerG45-2 SEE-THRU Series

L-A2-22907

REV 5 - 0711161227

FOR INSTALLATION IN A SEE-THRU FIREPLACE ONLY

Important: To comply with certiﬁ cation and building

code acceptance, and for safe operation

and proper performance, ONLY Peterson

parts and accessories may be used with

this gas log set.

The Peterson Real-Fyre

gas log set is to be installed

only in a solid-fuel-burning ﬁ replace with a working ﬂ ue

constructed of noncombustible material. Solid fuels

shall not be burned in a ﬁ replace where this gas log

set is installed. The installation, including provisions

for combustion, ventilation air, and required minimum

permanent vent opening, must conform with the National

Fuel Gas Code (ANSI Z223.1/NFPA 54) and applicable

local building codes. In Canada, the installation must

conform with the Natural Gas and Propane Storage and

Handling Installation Code (CSA-B149.1). A damper

clamp is included to maintain the minimum permanent

vent opening and to prevent full closure of the damper

blade. The chimney damper should be fully opened

when burning the log set.

Owner’s

Manual

Do not store or use gasoline or other ﬂ ammable

vapors and liquids in the vicinity of this or any other

appliance.

WHAT TO DO IF YOU SMELL GAS:

• Open a window.

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use

any phone in the building.

• Immediately call the gas supplier from a

neighbor’s phone. Follow the gas supplier’s

instructions.

• If you cannot reach the gas supplier, call the

ﬁ re department.

Important: Read these instructions carefully before

starting installation of the log set.

G45-2 SEE-THRU SERIES

INSTALLER & CONSUMER

These instructions MUST be retained

with this appliance for future reference.

Unregulated Burner

Systems:

G45-2-18/20(P)

G45-2-24(P)

G45-2-30(P)

GAS FIREPLACE LOG

SET

Robert H. Peterson Co.

DESIGN CERTIFIED

RGA - 72

Robert H. Peterson Co. • 14724 East Proctor Avenue • City of Industry, CA 91746

Installation and service must be performed

by an NFI Certified or other qualified

professional installer, service agency, or

the gas supplier.

WARNING

If the information in this manual is not followed

exactly, a ﬁ re or explosion may result, causing

property damage, personal injury, or loss of life.

Summary of content (18 pages)

PAGE 1
Robert H. Peterson Co. Owner’s Manual ® Unregulated Burner Systems: DESIGN CERTIFIED to RGA - 72 G45-2-18/20(P) G45-2-24(P) G45-2-30(P) GAS FIREPLACE LOG SET FOR INSTALLATION IN A SEE-THRU FIREPLACE ONLY G45-2 SEE-THRU SERIES Important: Read these instructions carefully before starting installation of the log set. WARNING If the information in this manual is not followed exactly, a fire or explosion may result, causing property damage, personal injury, or loss of life.
PAGE 2
TABLE OF CONTENTS TABLE OF CONTENTS GENERAL INFORMATION PARTS LIST PRE-INSTALLATION AND FIREPLACE PREPARATION SAFETY GUIDELINES IMPORTANT SAFETY INFORMATION DAMPER STOP CLAMP INSTRUCTIONS FOR YOUR SAFETY, READ BEFORE LIGHTING INSTALLING THE OPTIONAL REAL-FYRE® BURNER SPK & APK SYSTEMS INSTALLING THE REAL-FYRE® BURNER SPK SYSTEM (Cont.) INSTALLING THE REAL-FYRE BURNER® SYSTEM (Cont.
PAGE 3
GENERAL INFORMATION (Cont.) The Real-Fyre® gas log set is to be installed only in a fully vented, noncombustible fireplace with an open damper. The chimney must be free of any obstructions. The fireplace must be designed and approved to burn wood. The fireplace flue must be at least 8" at its smallest dimension. The fireplace must have a gas-supply line that has been installed by a qualified technician in accordance with all local codes. The gas-supply line must be 1/2" minimum interior diameter.
PAGE 4
PRE-INSTALLATION AND FIREPLACE PREPARATION SAFETY GUIDELINES CAUTION: Installation and repair must be done by an NFI Certified or other qualified, professional installer. Installer: Carefully read these instructions before installing this gas appliance. Be sure you understand all safety precautions and warnings contained in this manual. A. This appliance is designed as an attended appliance. Adults must be present when this gas appliance is operating.
PAGE 5
IMPORTANT SAFETY INFORMATION INSTALLATION SAFETY GUIDELINES A. Before installing in a solid-fuel-burning fireplace, the chimney, flue, and firebox must be cleaned of soot, creosote, ashes, and loose paint by a qualified chimney cleaner. B. Carefully inspect the burner and log cartons for shipping damage. If any parts are missing/damaged, call your dealer. Do not attempt to install the appliance unless all parts are in good condition. C.
PAGE 6
INSTALLING THE OPTIONAL REAL-FYRE® BURNER SPK & APK SYSTEMS Note: We recommend that before you install the log set, you familiarize yourself with the control valve layout. This will help you to be confident operating the log set when fully installed (see figures below for typical control positions). Aluminum tubing Air mixer/ fuel injector Check to see if the burner fuel injector or air mixer is installed on the side of the burner closest to the Flared Burner pan gas connection.
PAGE 7
INSTALLING THE REAL-FYRE® BURNER SPK SYSTEM (Cont.) e. Use a long-necked butane lighter, or lay a lighted match next to the burner pipe and carefully turn on the AV valve until the burner ignites. Burner pan Aluminum tubing Elbow f. Test for leaks at all connections with a soapy water solution. If bubbles appear, a leak is present. Turn off the gas and tighten all connections, then turn on the gas and repeat the leak test. Repeat until no leaks are detected. Never use a flame to check for leaks.
PAGE 8
INSTALLING THE REAL-FYRE BURNER® SYSTEM (Cont.) Elbow Burner pan Air mixer/fuel injector Gas-supply line Air mixer/fuel injector Burner pan Gassupply line Aluminum tubing Aluminum tubing Hearth elbow Adapter Remote safety valve Remote safety valve APK 10 Valve Note: Burner pan Burner pan The heat shield is not shown, but must be in place when operating the gas log set. Note: APK 11 Valve Fig. 8-1 - APK-10(P) The heat shield is not shown, but must be in place when operating the gas log set.
PAGE 9
INSTALLATION WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this appliance may result in proper ty damage or personal injury. EMBER PLACEMENT 1. Sprinkle embers (PARTS LIST, Item #9) lightly and evenly over the entire surface of the granules, making sure that the pilot is not covered (Fig. 9-2). Center the grate over the burner pans (Fig. 9-3).
PAGE 10
DR AF T This page ge intentionally intentio left blank.
PAGE 11
LIGHTING INSTRUCTIONS - MANUAL VALVE FOR YOUR SAFETY, READ BEFORE LIGHTING WARNING If you do not follow these instructions exactly, a fire or explosion may result, causing property damage, personal injury, or loss of life. Do not use this appliance if any part has been underwater. Immediately call for a qualified professional service technician to inspect the appliance and to replace any part of the control system and any gas control that has been underwater.
PAGE 12
EXAMPLE LOG PLACEMENTS GOLDEN OAK GOLDEN OAK GOLDEN OAK 12
PAGE 13
EXAMPLE LOG PLACEMENTS SPLIT LOG SPLIT LOG DRIFTWOOD (G4 ONLY) 13
PAGE 14
TROUBLESHOOTING YOUR GAS LOG SET SYMPTOM 1. Excessive smoking and sooting 2. Low flame CAUSE SOLUTION A. Poor draft or downdraft A. Check for chimney blockage. Be sure chimney is at least 3' taller than anything within 10' of it in all directions. If not, consult a chimney sweep. Chimney cap or fan may help. Under severe conditions, you may need to open a window near the fireplace about 1" to 2" when burning the log set. B. Improper burner for gas used B. Use only a natural-gas set with natural gas.
PAGE 15
TROUBLESHOOTING YOUR GAS LOG SET (Cont.) SYMPTOM 3. Uneven flame distribution (Lower at one end of the burner) 4. Flame at air mixer (For propane units) CAUSE SOLUTION A. Clogged or blocked portholes A. Portholes can be cleared of foreign object by running a wire through them. B. Insufficient gas pressure and/or supply B. Consult installer or plumber. (See solution 2b.) C. Granules may be packed down too tightly C.
PAGE 16
AVAILABLE ACCESSORIES FOR THE GAS BURNER SYSTEM The following accessories are available for burner systems as indicated, and can be purchased separately from your local Peterson Real-Fyre® dealer. Before purchasing, make sure the accessory you desire is compatible with your specific model (for example, VR-2A is used with the Series 15 systems). To install and operate any accessory, simply follow the instructions supplied with your accessory kit.
PAGE 17
AVAILABLE ACCESSORIES FOR THE GAS BURNER SYSTEM (Cont.) FOR SERIES 01, 10, 11, and 12: ON/OFF REMOTES AND RECEIVERS BATTERY-OPERATED REMOTE LIGHTING SYSTEMS FOR USE WITH NATURAL OR PROPANE GAS RR-2A RR-2A RR-1A RUS-1 Transmitter handset, Transmitter handset, receiver, wall switch, Transmitter receiver, handsethandset, holder, receiver,and wiring holder, wall switch, and wiring. wall handset switch, and wiring RUS-1 Transmitter handset, Transmitter handset, receiver.
PAGE 18
WARRANTY PETERSON VENTED GAS LOG SETS LIMITED WARRANTY All Peterson gas logs are WARRANTED for as long as you own them (lifetime). All Peterson burner assemblies are WARRANTED for TEN (10) YEARS. SPK-26 controls are covered by a THREE (3) YEAR “All Parts” Warranty. All other Peterson valves, pilots, and controls are covered by a ONE (1) YEAR Limited Warranty (excluding batteries).