Owner`s manual

7
5. Be sure gas to the fi replace is off. Attach the large
adapter (Item 4A) to the gas-supply stub using a pipe
compound resistant to all gases. Tighten securely. Then
attach the open end of the fl ex connector to the large
adapter. Tighten securely. Ensure the pan rests level
on the fi replace fl oor after connection. Adjust the pan if
necessary.
6. LEAK TEST: Use a long-necked butane lighter, or lay
a lighted match next to the burner pipe, and carefully
turn on the gas supply until the burner ignites. Test at
all connections for leaks using the appropriate soapy
water solution. If bubbles appear, a leak is present. Turn
off the gas and tighten at all connections. Repeat until
no leaks are present. If a leak persists, turn off the gas
supply and contact the local gas company or dealer.
NEVER USE A FLAME TO CHECK FOR LEAKS.
Turn off the gas supply prior to proceeding.
INSTALLATION (cont.)
Fig. 7-1 - Fireplace valve
Fuel injector / air mixer
Flex
connector
Large
Adapter
Burner pan
Gas
supply stub
Small
adapter