Owner`s manual

INSTALLATION

The damper clamp with hex bolt (Fig. 6-1) is provided as a means to prevent

full closure of the damper blade. The clamp is easily attached to most damper

blades with pliers or a wrench, and must be permanently installed. The clamp

is designed to prevent accidental closure of the damper when installed as

illustrated (

Fig. 6-2 and Fig. 6-3). Should the clamp not ﬁ t, or fail to provide the

permanent vent opening listed in the table found above, have a permanent

stop installed, remove the damper blade, or have the

damper cut to provide the minimum permanent opening

required.

Note: These are minimum damper opening

speciﬁ cations. The damper must be completely

opened when operating this gas appliance to

achieve the best ventilation possible.

INSTALLING THE BURNER

The Real-Fyre gas burner system must be installed by a qualiﬁ ed professional service technician. Instructions

must be followed carefully to ensure proper performance and full beneﬁ t from the gas burner system. Check to

be sure the burner system is designed and labeled for the type of gas (natural or propane gas) supplied

to the ﬁ replace. Fireplace ﬂ oor must be level, clean, and smooth.

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts

speciﬁ cally approved with this appliance may result in property damage or personal injury.

REFER TO THE PARTS LIST WHEN FOLLOWING THESE INSTRUCTIONS. If your burner is to be installed

with a pilot kit; carefully follow the instructions supplied with your pilot kit for speciﬁ c gas connection.

The burner pan is supplied with an air mixer for propane gas or a fuel injector for natural gas. The air mixer / fuel

injector must be used in ALL installations. The air mixer / fuel injector has a precisely sized oriﬁ ce to ensure

only the proper quantity of gas enters the burner. This allows maximum performance and gas conservation.

1. MAKE SURE THE FIREPLACE GAS SUPPLY IS TURNED OFF.

2. Locate the gas-supply stub inside the ﬁ replace and remove the cap, if attached (see Fig. 6-4).

CAUTION: When removing the cap, make sure the stub does not turn, loosening the connection inside the wall.

3. Attach the small adapter (Item 4C) to the fuel injector / air mixer on the burner pan, using a pipe compound

resistant to all gases. Tighten securely. DO NOT REMOVE THE FUEL INJECTOR / AIR MIXER. Then

attach one end of the ﬂ ex connector (Item 4B) to the small adapter. Tighten securely.

4. Place the burner system into the ﬁ replace so that it is centered and the open burner pan faces outward.

Fig. 6-1

Damper clamp

Set screw

Fig. 6-2 Fig. 6-3

Open

Closed

Fig. 6-4

Gas supply

line stub

Gas line

cap

4. Place the burner system into the ﬁ replace so that it is centered.