Owner`s manual

3
L-A2-265
REV 1 - 1009220843
PARTS LIST
GENERAL INFORMATION (Cont.)
The Real-Fyre
®
gas burner system is to be installed only
in a fully vented, noncombustible fi replace with an open
damper. The chimney must be free of any obstructions.
The fi replace must be designed and approved to burn
wood.
The fi replace must have a gas-supply line that has been
installed by a qualifi ed technician in accordance with all
local codes. The gas-supply line must be
1
/
2
" minimum
interior diameter. If the gas line to the fi replace is longer
than 20', a larger-diameter line may be necessary.
Be sure to clean the fi replace fl oor of any ashes or other
foreign materials. It is recommended that the fi replace
and chimney be inspected by a chimney sweep or other
qualifi ed person before you install the Real-Fyre
®
gas
burner system.
Required Gas Pressure: The minimum inlet gas-
supply pressure for the purpose of input adjustment is
7" water column (w.c.) for natural gas and 11" w.c. for
propane gas. The maximum inlet gas-supply pressure is
10.5" w.c. for natural gas and 13" w.c. for propane gas.
Testing the Gas-Supply System: The gas burner
system and its individual shutoff valve must be
disconnected from the gas-supply piping system while
performing any tests of the piping system at pressures
in excess of
1
/
2
psig. The gas burner system must be
isolated from the gas-supply piping system by closing
its individual manual shutoff valve during any pressure
testing of the gas-supply piping system at test pressures
equal to or less than
1
/
2
psig.
A fi replace screen must be in place when the system
is burning. Provisions for adequate combustion
air must be maintained. Unless other provisions for
combustion air are provided, the screen shall have
an opening(s) for introduction of combustion air.
Combustion air is adequate when all fl ames curl into
the fi replace and away from the screen. When a glass
fi replace enclosure (door) is used, leave the doors
fully open when the system is in operation.
4A
4B
4C
(PHOTOS NOT TO SCALE)
Replacement parts are available
through your local Real-Fyre
®
dealership.
2
3
5
6
ITEM No. DESCRIPTION QTY
1. Burner pan 1
2.
Fuel injector (nat. only) / air mixer
(propane only)
1
3.
Damper clamp with bolt 1
4.
Connector kit (with adapters) 1
5.
Separation grating
1
6.
Select sand granules (nat. only) or
vermiculite granules (propane only)
1
Before installation, check that your gas burner system is complete. See the PARTS LIST below. If any parts are
missing or damaged, contact your Real-Fyre
®
dealer before installing or using the burner. Be sure you know
the model and size of your set when ordering options or replacement parts and accessories.
1
Glass/gems packaged separately.
Quantity will vary, depending
on selection. Glass and gems
are available in various colors;
contact your dealer for further
details.