Owner`s manual

11
PILOT BURNER ADJUSTMENT (IF EQUIPPED)
The pilot burner is preset at the factory and should
normally not require any adjustment. However,
should adjustment be necessary, the following
steps should be taken:
With the pilot burner lit and the control knob in
the pilot position, remove the heatshield covers.
Adjust the screw located on the control valve (see
Fig. 11-1). Using a screwdriver, turn the pilot
adjustment screw slowly clockwise to reduce the
fl ame, or counterclockwise to increase the fl ame.
The adjustment screw can be turned so that the
pilot fl ame is completely extinguished. The pilot
fl ame should be a quiet soft blue fl ame with yellow
tipping that encircles the thermocouple tip.
Replace the heatshield covers. Turn the control
knob to the ON position to assure proper ignition
of the burner system.
Fig. 11-1
PILOT
ADJUSTMENT
Example of
burner pilot
fl ame with
thermopile
Example of
burner pilot
fl ame with
thermocouple
Pilot adjustment