Owner`s manual

6
L-A2-013
REV 5 - 1011081109
7. Center this assembly in the fi replace and place it
as far back in the fi replace as possible. Remove
the grate for the gas connection and granule/ember
placement.
8. Be sure gas to the fi replace is off. Attach the
large adapter (Item 9A) to the gas-supply stub
using a pipe compound resistant to all gases.
Tighten securely. Then attach the open end of the
fl ex connector to the large adapter. Tighten securely.
Ensure the pan rests level on the fi replace fl oor after
connection. Adjust the pan if necessary.
9. LEAK TEST: Use a long-necked butane lighter, or
lay a lighted match next to the burner pipe, and
carefully turn on the gas supply until the burner
ignites. Test at all connections for leaks using the
appropriate soapy water solution. If bubbles appear, a leak is present. Turn off the gas and tighten at all
connections. Repeat until no leaks are present. If a leak persists, turn off the gas supply and contact the
local gas company or dealer. NEVER USE A FLAME TO CHECK FOR LEAKS.
Turn off the gas supply prior to proceeding.
GRANULE, EMBER, AND GRATE PLACEMENT
GRANULE PLACEMENT
The granules supplied with the unit are specially selected for
use with either propane gas or natural gas. They maximize fl ame
distribution and reduce carbon buildup.
1. Fill the burner pan completely with the granules* (Item 11).
See Fig. 6-2. Avoid spilling the granules on the pilot kit (if
equipped).
*Note: Use only select sand for natural gas burners and
vermiculite for propane gas burners.
2. Slope the granules at the same angle as the burner pan. This is
important to ensure quiet lighting and even fl ame distribution.
EMBER PLACEMENT
Sprinkle the glowing embers (Item 10) lightly and evenly over the entire surface of the granules. Break up
any clumps that may have developed during shipment. (For Charred series log sets, refer to OPTIONAL
CHARRED SERIES INSTALLATION section.)
Important: Do not add any additional embers to this log set. Any additional embers may cause unsafe
operation.
GRATE PLACEMENT
Replace the grate so that the stabilizer clips fi t over the back edge of the pan, locking it in position.
Burner pan
Place granules in
pan & slope to angle
of pan
Back wall
of fireplace
Fig. 6-2 Granule placement
INSTALLATION (cont.)
CAUTION: Burn hazard. Logs will remain hot for some time after use. You must maintain the
log layout as shown to ensure proper operation of your log set. If you need to
reposition any log to maintain the proper layout, use heat-resistant gloves or allow
logs adequate time to cool before handling.
Styles and sizes will vary depending upon the log set ordered. If the log set ordered includes placement
instructions; follow those instructions.
LOG PLACEMENT
Fig. 6-1 - Fireplace valve
Fuel injector
Flex
connector
Large
adapter
Burner
Pan
Gas
supply line
Small
adapter