Owner`s manual

8
L-A2-256
Rev 5 - 1310220810
FLAME
DIVERTER
BRACKET
BURNER
PA N
2 1/2
REAR WALL
Burner pan
Flame
diverter
bracket
1-
1
/4"
INSTALLATION (Cont.)
INSTALL FLAME DIVERTER BRACKET
For installation on G4/G45 burners only. When properly
installed onto the burner pan, the fl ame diverter bracket
will promote quicker ignition and protect the safety control
system from overheating.
Note: You must fi rst install the fl ame diverter bracket
before installing the pilot/igniter assembly.
1. Place the fl ame diverter bracket over the side edge
of the burner pan, near the location the safety control
system pilot bracket will be attached. It should be
placed approximately 1-
1
/
4
" from the rear wall of
the burner pan (see Fig. 8-1).
2. Tap the bracket lightly with a hammer to secure it in
place.
INSTALL PILOT ASSEMBLY TO BURNER
CAUTION: Use only the pilot assembly pre-assembled
with this kit. Never substitute with an existing
pilot.
CAUTION: Do not kink or damage the pilot supply tube
and thermocouple lead. Do not unscrew the
gas line from the valve.
1. The pilot assembly comes with two Phillips screws
installed on the long side of the pilot bracket. Remove
the screws and use them to fasten the pilot assembly
to the burner pan using the pre-drilled holes in the
pan (see Fig. 8-2 and Fig. 8-3).
Note: Ensure the insulation is properly in place over the
pilot bracket. Screw from the inside of burner pan.
2. The valve is shipped with the pilot supply tube and
thermocouple lead bent in an ideal manner to prevent
damage / unsafe operation, and to allow for proper
heat shield placement. Maintain this orientation at all
times (reference Fig. 8-3).
WARNING: Keep the pilot assembly clear at all
times. Never cover any part of the pilot
assembly.
Fig. 8-1 Install diverter bracket (if applicable)
Fasten pilot
assembly to
burner pan
Fig. 8-2 Install pilot assembly
Fig. 8-3 Proper tube & lead orientation
(screw from
inside)