Owner`s manual

15
LIGHTING INSTRUCTIONS (cont.)
PILOT BURNER CHECK/ADJUSTMENT
With the pilot burner lit and the control knob in the pilot
position, check the pilot system for proper fl ame size and
appearance (see Fig. 15-1). The pilot adjustment screw is
located on the front of the gas valve (see Fig. 15-1). Using a
small fl at head screwdriver, adjust the pilot screw to properly
size the fl ames. Turning the screw clockwise will lower the
fl ames, and turning it counterclockwise will raise them. Be
careful not to back the screw out of its threads.
The pilot fl ame should be a quiet, soft blue fl ame with yellow
tipping that encircles the thermocouple tip.
SHUTTING DOWN
To extinguish the main burner (pilot will remain lit):
• For a remote shut down, press and hold the LO/OFF
button on the remote transmitter until the burner shuts
off.
If your remote is lost, slide the switch on the receiver
to the OFF position.
• For a manual shutdown, turn the control knob
clockwise to PILOT.
To extinguish the pilot:
• Push in the control knob slightly and turn clockwise
to OFF.
Fig. 15-1 Pilot adjustment detail
Pilot adjustment screw
ORIENTATION
Prior to remote transmitter use, light the appliance per the
REMOTE LIGHTING section. Familiarize yourself with the
transmitter keys, as illustrated in Fig. 15-2.
Identify the two transmitter keys:
• ON/HI KEY: This keys turn the system ON, and
increases the fl ame height.
• LO/OFF KEY: This keys decreases the fl ame height
and turn the system OFF.
FLAME HEIGHT
The fl ame height may be adjusted via the remote transmitter.
Press and hold the ON/HI key to increase the fl ame height.
Press and hold the LO/OFF key to decrease the fl ame height.
Note: Continuing to hold the LO/OFF key will turn off the
burner.
Thermocouple
PILOT VALVE
LO/OFF
ON/HI
Fig. 15-2 Remote transmitter detail
REMOTE OPERATING INSTRUCTIONS