Owner`s manual

13
LIGHTING INSTRUCTIONS (cont.)
2. Locate the remote transmitter and press the ON/HI
button (see Fig. 13-1). The ignition sequence will begin.
Note: Upon initial use or after an extended period of no
use, the ON/HI button may have to be pressed for
up to 3 seconds.
The remote receiver will emit an audible "beep"; then the
valve will automatically open and the burner will light.
Adjust to the desired setting with the remote transmitter.
See the REMOTE OPERATING INSTRUCTIONS
section for details.
Note: The ignition sequence will take approximately 5
seconds.
WARNING: If the burner fails to light within 10
seconds, press and hold the OFF button
on the remote transmitter and/or slide the
switch to the OFF position. Allow fi ve (5)
minutes for any gas in the unit to dissipate,
then repeat steps 1 and 2 above. IF YOU
SMELL GAS, SEE STEP B AT BEGINNING
OF LIGHTING INSTRUCTIONS.
If the burner fails to light after several tries, turn all control/
remote system components to OFF and contact a qualifi ed
professional service technician.
MANUAL LIGHTING
1. Ensure the pilot is burning. If equipped, locate the
3-position switch on the remote receiver (see Fig. 13-2),
and slide the switch to the OFF position.
2. Turn the gas control knob counterclockwise to ON
(Fig. 13-3) to ignite the burner. The valve will open and
the burner will light.
Note: The ignition sequence will take approximately 5
seconds.
WARNING: If the burner fails to light within 10
seconds, turn the control knob clockwise
to PILOT. Allow fi ve (5) minutes for any
gas in the unit to dissipate, then repeat
step 2 above. IF YOU SMELL GAS, SEE
STEP B AT BEGINNING OF LIGHTING
INSTRUCTIONS.
If the burner fails to light after several tries, push in the
control knob slightly and turn clockwise to OFF, and contact
a qualifi ed professional service technician.
LO/OFF
ON/HI
Fig. 13-1 Remote transmitter detail
LEARNADJ.
REMOTE ONOFF
Fig. 13-2 Remote receiver (OFF for Manual Light)
ON
OFF
ON
PILOT
OFF
ON
PILOT
OFF
ON
PILOT
Fig. 13-3 Control knob detail (ON)
For Manual
Lighting, turn knob
counterclockwise to
ON position.