Owner`s manual

11
PILOT
OFF
OFF
ON
PILOT
OFF
ON
PILOT
OFF
ON
PILOT
LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fi re or explosion may result causing property
damage, personal injury or loss of life.
A. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn
by hand, don't try to repair it. Call a qualifi ed professional service technician. Excessive force or attempted
repair may result in fi re or explosion.
B. BEFORE OPERATING, smell all around the appliance area for gas. Be sure to smell next to the fl oor
because some gas is heavier than air and will settle on the fl oor.
WHAT TO DO IF YOU SMELL GAS
• Do not light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
If you cannot reach your gas supplier, call the fi re department.
C. The burner system has a pilot that can be lit by hand using a match or long-necked lighter. When lighting
the pilot, follow these instructions exactly.
D. Do not use this appliance if any part has been under water. Immediately call a qualifi ed service technician
to inspect the appliance and to replace any part of the control system and any gas control which has been
under water. Attempted operation may result in fi re or explosion resulting in property damage, personal
injury or loss of life.
LIGHTING THE PILOT
1. Locate the valve on the side of the unit. Push in the
gas control knob slightly and turn clockwise to OFF
(Fig. 11-1).
Note: The control knob cannot be turned from PILOT to
OFF unless the knob is pushed in slightly. Do not
force.
Allow fi ve (5) minutes for any gas in the unit to dissipate.
IF YOU SMELL GAS, SEE STEP B ABOVE. If you don’t
smell gas, go on to step 2.
2. Turn the control knob counterclockwise to PILOT
(Fig. 11-1). Push the control knob fi rmly and fully
in and hold. Hold a long fi replace match or lighter
near the thermocouple to light the pilot. Continue to
hold the control knob in for approximately 60 seconds
after the pilot is lit, then release the knob. The pilot
will remain lit.
WARNING: If the pilot fails to light repeat steps 1
and 2.
If the pilot fails to light after several tries, turn the control
knob to OFF and contact a qualifi ed professional service
technician.
REMOTE LIGHTING (if equipped)
Note: Step 1 may not be required if previously done during
an earlier lighting.
1. Ensure the pilot is burning. Then locate the 3-position
switch on the remote receiver (see Fig. 11-2), and slide
the switch to the REMOTE position.
Fig. 11-1 Control knob detail (OFF, PILOT)
1. Turn knob clockwise
to OFF prior to lighting
the pilot.
2. Turn knob
counterclockwise to
PILOT position. Press
knob in, push piezo
button, and hold for
60 seconds while
lighting pilot.
LEARNADJ.
REMOTE ONOFF
Fig. 11-2 Remote receiver detail (REMOTE)