Owner`s manual

10
L-A2-256
Rev 5 - 1310220810
INSTALLATION (Cont.)
CONNECT REMOTE RECEIVER (if equipped)
1. Discard the black wires that come with the remote
receiver. Connect the valve wire harness to the valve
as shown in Fig. 10-1.
2. Connect the valve wire harness to the remote receiver
as shown in Fig. 10-2.
3. Place the receiver as far from the burner system as
possible.
4. Place the plastic cover over the remote receiver
with the open side facing front to allow access to the
receiver controls.
HEAT SHIELD PLACEMENT
Cover the valve with the heat shield as shown in Fig.
10-3 and Fig. 10-4. It is critical that the heat shield be
placed correctly over the valve for the unit to operate
properly. Keep the area above the heat shield clear of
decorative media or any other object.
Important: Ensure the pilot supply tube does not
interfere with heat shield placement.
CAUTION: Always keep granules and all foreign
objects away from the pilot assembly and
valve assembly.
DECORATIVE MEDIA REPLACEMENT
Refer to the burner instructions for proper replacement
of decorative media.
Fig. 10-3 Place heat shield
Fig. 10-4 Heat shield properly placed
LEARN
ADJ.
REMOTE
ON
OFF
Red wire
this side
Black wire
this side
Remote receiver
Valve
Insulation
Fig. 10-2 Connect harness to receiver
(from
remote
receiver)
Connect here
Wire
harness
Fig. 10-1 Connect harness to valve
Valve