Owner`s manual

10
EMBER COALS PLACEMENT
Attach the ember bed to the burner by slipping it
onto the back edge (center left to right) with the
perforated section facing towards the back fi replace
wall.
Cover the surface of the ember bed with the ember
coals (Fig. 10-1). For best glowing performance,
they should be applied evenly and pulled slightly
apart so the fi bers are somewhat loose. (It is not
necessary to pile the entire bag of the ember coals.
More ember coals may be added after completion
of the entire installation.)
GRATE REPLACEMENT
Follow the instructions on page 7.
These instructions must be used with the Charred series gas log set series
Note: Ember bed(CHD-01) included with Charred Series
log sets only.
Fig. 10-1a
Fig. 10-1
Part No. CHD-01
CHARRED SERIES LOG PLACEMENT
Place the long bottom rear log (Log #2) on the back of the grate with the fl at hollow side facing the rear of
the fi replace. The two sections of the front log (Logs #1A & 1B) are placed on the front of the grate with
the charred sections facing each other and positioned approximately 1" apart at the top (Fig. 10-2). There
should be 3" between the front and rear logs.
Place the two top knothole logs (Logs #3 & 4) so that one end rests on each front log (Logs #1A & 1B) and
the other end on the rear log (Log #2). The charred sections should be over the opening between the front
and rear logs (Fig. 10-3).
Place the small top charred log (Log #5) between the knothole logs so it rests on the rear log (Log #2) and
the right-hand front log (Log #1B) with the charred section facing the front (Fig. 10-4).
Place the curved top charred log (Log #6) so the charred section rests on the left-hand front log (Log #1A)
and the other end rests on the middle of the right top knothole log (Log #4); see Fig. 10-5.
Place the additional top log (Log #7) on the top in the desired position. Additional log not available with 18"
log set.
* Other options may be chosen for top log placement.
Light the log set, referring to installation instructions for procedures. More ember coals may be placed on
the ember bed for the added realism of a burning-wood look.
Fig. 10-2
LOG #1A
LOG #2
LOG #1B
3"
Fig. 10-3
LOG #3
LOG #4
Fig. 10-4 Fig. 10-5
LOG #7
Note: Charred Oak (CHD) log set used for illustration.
LOG #6
LOG #5
Ember bed
CAUTION: Burn hazard. Logs will remain hot for some time after use.
YOU MUST MAINTAIN THE LOG LAYOUT AS SHOWN TO ENSURE PROPER OPERATION OF THE
LOG SET. IF YOU NEED TO REPOSITION ANY LOG TO MAINTAIN THE PROPER LAYOUT, USE HEAT
RESISTANT GLOVES OR ALLOW LOGS ADEQUATE TIME TO COOL BEFORE HANDLING.
CHARRED SERIES SUPPLEMENTAL INSTRUCTIONS
REV 2 - 100429952
L-A2-271