Owner`s manual

REV 7 - 0903130830

No. L-A2-17509

LIGHTING THE GAS LOG SET

1. Lay a lighted long-stem match on the surface of the embers near the gas inlet (do not hold the match

in your hand) or use a lighted long-necked butane lighter.

2. Slowly turn the ﬁ replace remote valve to the ON position. The log set should light.

3. If the log set does not light before the match goes out, immediately turn the valve off.

4. Wait approximately ﬁ ve (5) minutes to clear out any gas, and repeat steps 1-3 above. Smell for gas

including near the ﬂ oor. If you smell gas, stop and follow step B above. If you don’t smell gas, proceed.

5. If the log set fails to light again, turn off the valve and contact the dealer or gas supplier.

TURNING OFF THE GAS LOG SET

1. To extinguish; simply turn the valve to the OFF position. Be sure the valve is turned completely off to avoid

any gas leakage.

FOR YOUR SAFETY, READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a ﬁ re or explosion may result, causing property

damage, personal injury, or loss of life.

A. BEFORE LIGHTING, smell all around the gas

log set area for gas. Be sure to smell next to the

ﬂ oor because some gas is heavier than air and

will settle on the ﬂ oor.

B. IF YOU SMELL GAS:

• Shut off the gas to the appliance.

• Extinguish any open ﬂ ame.

• If odor continues, keep away from the

appliance, and immediately call the gas

supplier or ﬁ re department.

C. Do not use the gas log set if any part has been

underwater. Immediately call a qualiﬁ ed service

technician to inspect the gas log set and to replace

any part of the control system and any gas control

that has been underwater.

OPERATING THE LOG SET - LIGHTING AND EXTINGUISHING