Owner`s manual

9
L-A2-102
Rev 8 - 1501081400
INSTALL/REPLACE BATTERIES FOR IGNITION
MODULE PACK
Two 1.5-volt (D-cell) alkaline batteries are supplied with
the burner system. To install or replace batteries, remove
any old batteries (if applicable) and install new batteries
according to the diagram illustrated on the battery holder
mounted inside the switch box (
Fig. 9-1).
Note: For the system to work properly, it is suggested
that you replace the batteries annually with fresh
batteries. Always replace both batteries at the
same time.
CONNECT REMOTE RECEIVER (if equipped)
1. Install the provided batteries in the remote transmitter
and receiver.
2. Connect the remote receiver wires to the switch box
(see Fig 9-1).
3. Place the receiver as far from the burner system as
possible (reference fi gure on next page).
Note: Place the receiver a minimum of 6" from the
burner/fl ame.
4. Place the plastic cover over the remote receiver
with the open side facing front to allow access to the
receiver controls.
HEAT SHIELD PLACEMENT
TO PREVENT VALVE DAMAGE AND FAILURE:
IT IS CRITICAL THAT THE HEAT SHIELD BE
PLACED CORRECTLY OVER THE VALVE PRIOR
TO OPERATION.
TO PREVENT OVERHEATING THE VALVE:
Cover the valve with the heat shield as shown in Fig. 9-2.
It should rest fl at above the valve.
Keep the area above and below the heat shield clear
of decorative media or any other objects at all times.
Important: Ensure the wire bundles do not interfere
with heat shield placement. Reference
fi gure on next page for example placement.
Important: Keep sand, lava granules, and all foreign
objects away from the pilot assembly, valve
assembly, and heat shield during media
placement and at all times.
Fig. 9-2 Place heat shield
HEAT SHIELD
MUST BE
PROPERLY
PLACED
Fig. 9-1 Switch box detail
ON/OFF
switch
Ignitor pack
Battery
pack
Switch
box
Connect wires
INSTALLATION (Cont.)