Owner`s manual

8
L-A2-102
Rev 8 - 1501081400
TO CHECK THE WIRING ASSEMBLY
1. Check that the wiring harness is fi tted tightly into the
connector on the green ignitor pack in the rear of the
switch box (Fig. 8-1).
2. Check that the female connectors on the two black
wires from the pilot assembly (wires marked "I" and
"S") are inserted fully into the male connectors on the
ignitor pack (Fig. 8-1).
3. Check the connection of the red and black wires of the
wire harness to the respective counterpart wires from
the battery holder (red-red and black-black). The two
brown wires should be connected to the switch.
Note: The two (2) spare brown wires with coated male
connectors are used to connect an optional remote
system.
4. Check the connections of the wires to the EPK-1(M)
(P) valve (see Fig. 8-2):
Orange wire marked THTP - to THTP connector on valve
Black wire marked TP - to TP connector on valve
Green wire marked TH - to TH connector on valve
The diagram below (Fig. 8-3) shows the wiring layout for
the complete unit.
Green
wire
marked
“TH”
Black
wire
marked
“TP”
Check connections
Orange
wire
marked
“THTP”
D
Fig. 8-2
Check connections
"I" Wire
"S" Wire
Wire harness
connector
Iginitor pack
B
A
Fig. 8-1
Ignitor pack
Wire harness
connector
Check connections
"I" wire
"S" wire
Check connections
Orange
wire
marked
"THTP"
Green wire
marked
"TH"
Black wire
marked
"TP"
For installation of a remote system (if equipped), see
instructions included in the remote kit fi gure on next page.
2x D cells
(Black) to
Battery
holder
(Red) to
battery holder
Rear of control panel
Brown 2 wires
to switch (inside
of switch box)
Remote
receiver
(optional)
Wire harness
Remote valve
Valve magnet wire
(black)
(do not remove)
Orange (THTP)
Black (TP)
Green (TH)
I
Ignitor pack
S
Ignitor
Sensor
S
I
To pilot assembly
probes
Fig. 8-3
Consult this wiring diagram to ensure correct connection of wires.
Switch
Switch box
Wiring diagram for EPK-1(M)(P)
INSTALLATION (Cont.)
CHECKING THE IGNITION PACK
The EPK-1(M)(P) valve comes completely assembled with the wiring harness already connected to the
switch box assembly. However, we recommend that you follow the steps below to ensure it has not become
detached during shipping before installing the batteries.