Owner`s manual

L-A2-102

Rev 8 - 1501081400

INSTALLATION (Cont.)

INSTALL PILOT ASSEMBLY TO BURNER

CAUTION: Use only the pilot assembly pre-assembled

with this kit. Never substitute with an existing

pilot.

CAUTION: Do not kink or damage the pilot supply tube,

sparking, and sensor probes. Do not unscrew

the gas line from the valve.

1. The pilot assembly comes with an L-shaped mounting

bracket. Using the two black screws, fasten the bracket

to burner pan (short side toward the back of the pan)

using the pre-drilled holes in the pan (see Fig. 6-1).

2. Using the two (2) remaining screws, mount the pilot

assembly onto the bracket (Fig. 6-2) and tighten

until snug. Check to be certain the pilot hood and

probes are situated above the edge of the pan.

Adjust if necessary.

WARNING: Keep the pilot assembly clear at all

times. Never cover any part of the pilot

assembly.

Fig. 6-2 Install pilot assembly

Fig. 6-1 Install pilot bracket

(Valve not shown for clarity)