Owner`s manual

6
L-A2-10208
Rev 3 - 0801151103
I
S
I
S
Wiring diagram for EPK-1(M)(P)
Fig. 6-3
Consult this wiring diagram to ensure correct connection
of wires.
TO CHECK THE WIRING ASSEMBLY
1. Check that the wiring harness is fi tted tightly into the
connector on the green ignitor pack in the rear of the
pine cone (Fig. 6-1).
2. Check that the female connectors on the two black
wires from the pilot assembly (wires marked "I" and
"S") are inserted fully into the male connectors on the
ignitor pack (Fig. 5-1).
3. Check the connection of the red and black wires of the
wire harness to the respective counterpart wires from
the battery holder (red-red and black-black). The two
brown wires should be connected to the switch.
Note: The two (2) spare brown wires with coated male
connectors are used to connect an optional
remote system.
4. Check the connections of the wires to the EPK-1(M)
(P) valve (see Fig. 6-2):
Orange wire marked THTP - to THTP connector on valve
Black wire marked TP - to TP connector on valve
Green wire marked TH - to TH connector on valve
The diagram below (Fig. 6-3) shows the wiring layout
for the complete unit.
INSTALLATION (Cont.)
CHECKING THE IGNITION PACK
The EPK-1(M)(P) valve comes completely assembled with the wiring harness already connected to the
pine cone switch assembly. However, we recommend that you follow the steps below to ensure it has not
become detached during shipping before installing the batteries.
Green
wire
marked
“TH”
Black
wire
marked
“TP”
Check connections
Orange
wire
marked
“THTP”
D
Fig. 6-2
Check connections
"I" Wire
"S" Wire
Wire harness
connector
Iginitor pack
B
A
Fig. 6-1
Ignitor pack
Wire harness
connector
Check connections
"I" wire
"S" wire
Check connections
Orange
wire
marked
"THTP"
Green wire
marked
"TH"
Black wire
marked
"TP"
EPK-1(P) valve
Green (TH)Wire harness
Black (TP)
Orange (THTP)
To pilot assembly
probes
Switch
Pine cone
(Brown-2 wires)
to switch
(Black)
to battery
holder
(Red) to battery
holder
Valve magnet wire
(black) (DO NOT
REMOVE)
For installation of a remote system (if equipped), see
instructions included in the remote kit and p. 3, Fig.
3-1.
Remote
Receiver