Owner`s manual

5
L-A2-10208
Rev 3 - 0801151103
INSTALLATION (Cont.)
INSTALLING THE PILOT ASSEMBLY TO THE
BURNER
Caution: Do not kink or damage the pilot supply
tube, sparking, and sensor probes. Do not
unscrew the gas line from the valve.
1. The pilot assembly comes with an L-shaped mounting
bracket (Item #5). Using the two black screws (Item
#6), fasten the bracket to burner pan (short side
toward the back of the pan) using the pre-drilled holes
in the pan (see Fig. 5-1).
2. Using the two (2) remaining screws (Item #7), mount
the pilot assembly onto the bracket (Fig. 5-2) and
tighten until snug. Check to be certain the pilot
hood and probes are situated above the edge of
the pan. Adjust if necessary.
WARNING
Keep the pilot assembly clear at all times. Never
cover any part of the pilot assembly.
CONNECTING TO THE GAS SUPPLY
To connect the EPK-1(M)(P) to the gas supply, the
connector kit and component parts will be needed,
which are included with the burner system. Refer
to the PARTS LIST in the instructions supplied
with the burner to identify the key parts needed.
1. Apply gas pipe sealing compound (or Tefl on tape) to
the male end of the gas stub. Attach the hearth elbow
from the connector kit to the gas-supply stub in the
fi replace.
2. Attach the tubing of the connector kit to the elbow
on the EPK-1(M)(P) control valve (see Fig. 5-3). Use
Tefl on tape or pipe compound. Tighten securely.
(Discard the smaller connector elbow from the
connector kit, as this is not needed.)
3. Connect the tubing to the hearth elbow on the gas
stub. Tighten both ends securely.
4. Follow the instructions supplied with the Peterson
burner system for proper burner placement.
5. Turn on the gas supply and test for leaks at all
connections with a soapy water solution. Never use
an open fl ame to check for leaks.
Note: Although the fl ex connector supplied with the
burner system (not with this kit) should be
suffi cient for right-side supply installation (Fig.
5-4), for a left-side gas supply, a longer fl ex
hose may be required to reach the valve (Fig.
5-5).
Attach the
connector to
the adapter on
the valve
Fig. 5-3
1. Fasten
bracket
to burner
pan
2. Fasten
pilot
assembly
to bracket
PILOT ASSEMBLY
INSTALLED
Fig. 5-4
Fig. 5-5
Right-side gas-supply connection
Left-side gas-supply connection
Fig. 5-1
Fig. 5-2
Gas
connection