Owner`s manual

3
L-A2-10208
Rev 3 - 0801151103
2
8
12
Velcro
strips
ON/OFF
Switch
Rear view of the pine cone assembly
showing battery & ignition module packs.
FOR WIRING DIAGRAM & WIRE COLORS,
SEE P. 6
4
13
Photos not to scale
EPK1 PINE CONE
WIRING HARNESS
CONNECT FEMALE FROM OPTIONAL REMOTE
TO MALE ON EPK1- (BROWN WIRES)
TO OPTIONAL REMOTE
SYSTEM
Connecting a remote receiver
1
3
9
11
5
6
7
EPK-1(M)(P) PARTS LIST
Note: Unit is shipped pre-assembled, ready for installation.
DO NOT REMOVE THE PILOT ASSEMBLY FROM THE VALVE OR PINE CONE.
Parts are shown below separated
for identifi cation purposes only.
Pilot gas line
EPK-1(P) pine cone
Wiring harness
To remote receiver
Connect female from optional remote
to male on EPK-1(P) (brown wires)
Item No. Description
1. Pilot assembly, natural gas
or Pilot assembly, propane gas
2. Valve, natural or propane gas
3. Ignition module pack
4. Valve heat shield
5. Pilot mounting bracket
6. Screw #10 x
3
/
8
" Phillips BLK (2)
7. Mounting screws 10-32 x
1
/
4
" (2)
8. Brass adapter without plug
9. Pine cone with switch
10. Wire harness, 24"
11. Batteries (D-cells) (not installed)
12. Elbow, brass
3
/
8
" x
3
/
8
"
13. Flame diverter bracket
14. Remote kit (if equipped)
10
Remote kit (if equipped)
and remote instructions
14
Input pressure tap
Output pressure tap
Fig. 3-1