Owner`s manual

The Real-Fyre gas log set must be installed by a qualiﬁ ed professional service technician. Instructions must

be followed carefully to ensure proper performance and full beneﬁ t from the gas log set. Check to be sure the

log set is designed and labeled for the type of gas (natural or propane gas) supplied to the ﬁ replace.

Fireplace ﬂ oor must be level, clean, and smooth.

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts

speciﬁ cally approved with this appliance may result in property damage or personal injury.

BURNER INSTALLATION

REFER TO THE BURNER PARTS LIST WHEN FOLLOWING

THESE INSTRUCTIONS.

1. MAKE SURE THE FIREPLACE GAS SUPPLY IS

TURNED OFF.

2. Locate the gas-supply stub inside the ﬁ replace and

remove the cap, if attached (reference Fig. 8-1).

CAUTION: When removing the cap, make sure the stub does

not turn, loosening the connection inside the wall.

3. Place the burner system in the ﬁ replace. Center the

burner in the ﬁ replace. (Reference Fig. 8-2 for orientation.)

4. Be sure gas to the ﬁ replace is off. Remove the adapter

that is loosely connected to the ﬂ ex connector (coming off

of the burner system). Attach the adapter to the gas-supply

stub using a pipe compound resistant to all gasses. Tighten

securely. Then attach the open end of the ﬂ ex connector

to the adapter. Tighten securely. (See Fig. 8-1.)

5. LEAK TEST: Turn on the ﬁ replace gas supply, and test

at all connections for leaks using the appropriate soapy

water solution. If bubbles appear, a leak is present. Turn

off the gas and tighten at all connections. Repeat until

no leaks are present. If a leak persists, turn off the gas

supply and contact the local gas company or dealer.

NEVER USE A FLAME TO CHECK FOR LEAKS.

6. Using the appropriate hardware for your ﬁ replace

construction (not included); secure the burner system

into the ﬁ replace ﬂ oor. The unit has two anchoring tabs,

reference Fig. 8-3.

7. Remove the protective coating off of the reﬂ ective rear

panel and front cover. DO NOT use a sharp object to

remove coating. Install the front cover onto the front of

the burner system (see Fig. 8-4).

Turn off the gas supply prior to proceeding.

Fig. 8-1 Connect gas supply

Fig. 8-2 Overall orientation (24" shown)

Fig. 8-4 Front cover installed

Fig. 8-3 Anchoring tab close up

Flex connector

Adapter

Gas supply stub