Owner`s manual

BURNER INSTALLATION (Cont.)

9. Remove the protective coating off of the reﬂ ective rear

panel and front cover . DO NOT use a sharp object to

remove coating. Install the front cover onto the front of

the burner system (see Fig. 15-1 ).

Turn off the gas supply prior to proceeding.

REMOTE SYSTEM (if equipped)

If the unit is equipped with a remote; r ead and follow the

separate instructions (packed with the remote) for complete

remote installation.

CONTROL SETTINGS

We recommend that before you install the decorative media,

you familiarize yourself with the control valve layout. This will

help you to be conﬁ dent operating the burner system when

fully installed. See Fig. 15-2 for typical control positions.

The burner system and its main gas valve must be disconnected from the gas-supply piping system during any

pressure testing of that system at test pressures in excess of

psig (3.5 kPa). The burner system must be

isolated from the gas-supply piping system by closing its equipment shutoff valve during any pressure testing

of the gas-supply piping system at test pressures equal to or less than

psig (3.5 kPa). This is accomplished

by closing the gas-supply line valve.

IMPORTANT

For all valves, the air MUST be purged from the gas line before the pilot will light and burn properly. The

time needed to purge will depend on the length of the gas line to the unit and the amount of time since

the unit or gas line was last used. It may take several minutes before all the air is purged and the pilot

will light and burn properly. Reference the LIGHTING INSTRUCTIONS section in this manual.

IMPORTANT

Check the gas pressure with the system burning and the control fully ON.

Fig. 15-2 Control valve operating positions

OFF PILOT ON

Read settings here

Fig. 15-1 Front cover installed