Owner`s manual

EVENING FYRE SPLIT LOG PLACEMENT

Log placement is critical to ensure stability of the logs and proper performance of the Real-Fyre

gas log set.

Be sure to follow the log placement instructions carefully! (Reference the appropriate LOGS PARTS LIST.)

1. Each log in the Real-Fyre

unvented gas log set is numbered to aid in the log placement procedures. Set

the rear log at the back of the burner. Slide it forward so that the rear of the main burner bracket ﬁ ts into the

two (2) locating grooves in the front face of the log. Align the bottom of the front log with the corresponding

holes found in the burner. (See Fig. 24-1.)

Fig. 24-1

2. Position the middle logs (Logs #3, #4 and #5) into the appropriate grooves on the bottom logs as shown in

Fig. 24-2.

3. Position the two top logs (Logs #6 and #7) into the grooves atop logs #3, #4, and #5 as shown in Fig. 24-3.

24" log set shown

Fig. 24-3

Fig. 24-2

Each log must be properly and ﬁ rmly situated. The unvented gas log set will not function as intended if the logs

are not correctly positioned. When placed properly, the ﬂ ames will not strike any portion of logs #3, 4, 5, 6, or 7.

Periodically check the positioning of all logs to ensure proper log placement and stability. If any ﬂ ame is striking

any of the logs, recheck log placement. Adjust to conform with instructions. There should be no ﬂ ame touching

these logs.

CAUTION: BURN HAZARD. Logs will remain hot for some time after use. You must maintain the

log layout as shown to ensure proper operation of the log set. If you need to reposition

any log to maintain the proper layout, use heat-resistant gloves or allow logs adequate

time to cool before handling.

INSTALLATION (Cont.)

Place the wood chips as instructed and shown on the bottom of the previous page.

Ensure notches in face of

REAR log slide over rear

of bracket