Owner`s manual

23
WOOD CHIP PLACEMENT
The decorative wood chips provided with the log set are for aesthetics only and do not affect operation of
the G18 series unvented gas log set. The wood chip with the circular design should be placed in front of the
valve, with at least a
1
/
2
inch between it and the valve.
The other wood chip should be placed on the opposite
side (see Fig. 23-4).
Note: The wood chip may be HOT during and directly
after operation of the gas log set. Do not place
the wood chip on or in the log set.
EVENING FYRE / EVENING FYRE CHARRED LOG PLACEMENT
Log placement is critical to ensure stability of the logs and proper performance of the Real-Fyre
®
gas log set.
Be sure to follow the log placement instructions carefully! (Reference the appropriate LOGS PARTS LIST.)
1. Each log in the Real-Fyre
®
unvented gas log set is numbered to aid in the log placement procedures.
Set the rear log at the back of the burner. Slide it forward so that the rear of the main burner bracket fi ts
into the two (2) locating grooves in the front face of the log. Align the bottom of the front log with the
corresponding holes found in the burner. (See Fig. 23-1.)
INSTALLATION (Cont.)
2
1
A
Ensure notches in face of
REAR log slide over rear
of bracket
Fig. 23-1
AA
2. Position the middle logs (Logs #3, #4, and #5) on top of the bottom logs. Locate the logs so that each log
rests in the corresponding slots on the bottom front log and bottom rear log (see Fig. 23-2).
3. Position the top left log (Log #6) on the top of the middle logs # 3 and #4, and bottom front log. Locate
the top center log (Log #7) on top of Log #6 and Log #4. The logs should rest in the corresponding slots.
(See Fig. 23-3).
Fig. 23-3
7
6
Fig. 23-2
4
3
After setting the logs into position as described above, ensure each is properly and fi rmly seated. The unvented
gas log set will not function as intended if the logs are not correctly positioned. When placed properly, the
fl ames will not strike any portion of logs #3, 4, 5, 6, or 7. Periodically check the positioning of all logs to ensure
proper log placement and stability. If any fl ame is striking any of the logs, recheck log placement. Adjust to
conform with instructions. There should be no fl ame touching these logs.
CAUTION: BURN HAZARD. Logs will remain hot for some time after use. You must maintain the
log layout as shown to ensure proper operation of the log set. If you need to reposition
any log to maintain the proper layout, use heat-resistant gloves or allow logs adequate
time to cool before handling.
Wood chip
(circular design)
Wood
chip
Fig. 23-4
F
i
g
. 2
3
2
3--
7
7
7
7
7
7
7
7
7
7
7
66666
6
6
66
6
6
6
6
6
5
6
7
(Evening Fyre shown)