Owner`s manual

This appliance is for installation in a solid-fuel-burning ﬁ replace (masonry ﬁ replace or manufactured ﬁ replace)

with a working ﬂ ue and constructed of noncombustible material.

These gas logs may be installed as vented decorative log sets in compliance with ANSI Z21.60b-2004 and

National Fuel Gas Code, Section 6.6. The minimum permanent free opening of the ﬁ replace chimney or chimney

damper must be met per the Chimney Vent Opening Table on pg 3 of this manual. Chimney damper must be

ﬁ xed in a manner to maintain permanent free opening at all times. To accomplish this, install a screw or bolt

in the edge of the damper to prevent closing, or drill holes in the damper or remove the damper.

BEFORE PROCEEDING, CAREFULLY READ ALL OF THE IMPORTANT SAFETY INFORMATION

CONTAINED IN THIS OWNER’S MANUAL, INCLUDING:

A. Pre-Installation and Fireplace Preparation Safety Guidelines

B. Ventilation and Conﬁ ned Space Information

C. Installation Safety Guidelines

CHECK GAS TYPE (natural or L.P.). The gas supply must be the same as stated on the gas log set

rating plate. If the gas supply is different, DO NOT INSTALL. Contact the dealer for immediate

assistance.

1. Adjustable open-ended wrench

2. Pliers

3. L.P. gas-resistant pipe compound or Teﬂ on tape

4. Soapy water solution and brush for leak detection

5. Standard screwdriver

6. Manometer (for checking gas pressure)

Tools Required:

Note: To install the unvented gas log set, the ﬁ replace must have a gas-supply line that has been

installed by a qualiﬁ ed professional service technician in accordance with all local codes.

Refer to the PARTS LIST when installing the unvented gas log set.

IMPORTANT

Be sure you have read and understand all safety precautions and warnings

contained in this manual.

1. MAKE SURE THE FIREPLACE GAS SUPPLY IS TURNED OFF.

2. Center the burner assembly in the ﬁ replace. Make certain that no part of the assembly protrudes beyond the

face of the ﬁ replace.

3. Attach the large adapter ﬁ tting of the ﬂ ex connec tor kit to the ﬁ replace gas-supply line using pipe compound

resistant to L.P. gas or Teﬂ on tape. Tighten the connection. Connect one end of ﬂ ex connector to the large

adapter and the other end to the adapter on the valve assembly.

Refer to the PARTS LIST when installing the unvented gas log set.

WARNING

Do not connect this appliance directly to a high-pressure natural gas line or an unregulated L.P. tank.

LEAK TESTING

Make sure that the control valve on the burner system is in the OFF position. Carefully turn on the gas to the

ﬁ replace and leak test at all connections with a soapy water solution (equal parts liquid detergent and water). If

bubbles appear, a leak is present. Turn off the gas and tighten all connections, then turn on the gas and repeat

the leak test. Repeat until no leaks are detected.

NEVER USE A FLAME TO CHECK FOR GAS LEAKS.

L.P.

WHEN USED AS A VENTED DECORATIVE APPLIANCE (PER ANSI Z21.60b-2004)

CONNECTING THE GAS TO THE BURNER SYSTEM