Owner`s manual

20
INSTALLATION (Cont.)
1. Use the space between the grate
and main burner as a guide to set
the two (2) bottom logs (Logs #1)
in their approximate positions, as
shown in Fig. 20-4.
2. Position the two (2) “Y”-shaped top
logs (Logs #2) on top of the two (2)
bottom logs (Logs #1), as shown in
Fig. 20-5. Fit the “Y”-shaped log
into the notch on the bottom log
(Log #1), and the other two ends into
the notches on the opposite bottom
log.
3. Position the two (2) top side logs
(Logs #3) over the bottom logs (Logs
#1) as shown in Fig. 20-6. Place
top log over the matching notch on
the bottom log and the other side
over the notch on the “Y”-shaped
log (Log #2).
LOG PLACEMENT STEPS
Each log in the Real-Fyre
®
heater gas log set is numbered to aid in the log placement procedures. Each log
also has seating notches that stabilize the logs together in their correct position.
1
1
2
1
2
2
3
3
3
4
4
Fig. 20-4
Fig. 20-1
Fig. 20-5
Fig. 20-6
24" LOG SET
16/18" LOG SET
24" LOG SET
16/18" LOG SET
Fig. 20-2
Fig. 20-3
1. Both bottom logs are equipped with
specifi c indentations for both the
valve (Log #1) and the ODS pilot
(Log #2). Position the logs according
to these cutaways, as shown in Fig.
20-1.
2. Position the middle top log (Log
#3) on the top of the bottom logs
(Logs #1 and #2). Fit into matching
notches as shown in Fig. 20-2.
3. Position the two (2) “Y”-shaped
top logs (Logs #4) over the bottom
logs as shown in Fig. 20-3. Place
one side of “Y”-shaped log over the
notch on middle top log (Log #3)
and the other side on notch over the
bottom logs (Logs #1 and #2).
1
2
1
1