Owner`s manual

19
GLOWING EMBER PLACEMENT
The Glowing Embers are supplied in a single bag (Fig. 19-2). It is important that the embers be used in the
designated application and that no additional embers be added. Open the bag and spread the embers
loosely along the entire length of the ember burner (Fig. 19-4), from left to right on the burner and
on the vertical portion of the ember burner. Break up any clumps that may have developed during
shipment and make sure the embers are spread evenly over the entire area. Bryte Coals
TM
are placed
over glowing embers, also spread out evenly (Fig. 19-3 & 19-4). Failure to follow these instructions will result
in unsafe operation.
Important: DO NOT ADD ANY ADDITIONAL EMBERS OR BRYTE COALS
TM
TO THIS LOG SET. ANY
ADDITIONAL EMBERS MAY CAUSE UNSAFE
OPERATION.
Fig. 19-2
Fig. 19-3
Fig. 19-4
INSTALLATION (Cont.)
LAVA-FYRE GRANULES
TM
PLACEMENT
Lava-Fyre Granules
TM
are provided as an aesthetic enhancement to the G18-2 unvented gas log set.
Spread the granules on the fl oor of the fi rebox, around the front and both sides of the unvented gas log set.
Note: Do not cover burner with granules; use the supplied embers only.
Important: Be sure that no granules enter the main burner or interfere with the burning of the log set.
WOOD CHIP PLACEMENT
The decorative wood chips provided with the log set are for aesthetics only and do not affect operation of the
G18-2 log set. The two (2) wood chips with the circular design on top should be placed in front and back of the
valve, with at least a
1
/
2
" between it and the valve (Fig. 19-1). The other two (2) wood chips are for the opposite
side and are for both front and back (i.e., both fi replace openings).
CAUTION: The wood chip may be HOT during and directly after operation of the gas log set.
Note: Do not place the wood chips on the logs or burner.
Fig. 19-1 (24" Model Shown)
Wood
chip
(circular
design)
Wood
chip