Owner`s manual

3
SPECIFICATIONS AND REQUIREMENTS
Burner Model
Minimum Fireplace Size
(refer to Fig. 3-1)
BTU Input Rating
Width Depth Height
High Setting Low Setting
Natural Gas Propane Gas Natural Gas Propane Gas
G10-16/18
22" front
20" rear *
13" 18" 35k 32k 26k 24k
* based on minimum depth
WARNING: This appliance is for installation only in a:
1. Solid-fuel-burning masonry or UL-127
factory-built fi replace, or
2. Listed ventless fi rebox enclosure.
It has been designed certifi ed for these installations.
Exception: DO NOT install this appliance in a factory built
fi replace that includes instructions stating it has not been
tested or should not be used with unvented gas logs.
Note: Installation in any other fi replace is prohibited and
will void any approvals and warranties.
Fireplace Dimensions
Fig. 3-1
The G10 Series vent-free gas log sets are available
with a manual ODS pilot, an on-off remote, or a variable
fl ame height control valve that can be used with the
remote transmitter and receiver.
A spark ignition system (piezo) allows the gas pilot to be
lit without the use of matches, and permits the operation
of the appliance during a power outage.
This burner system is equipped with an Oxygen
Depletion Sensor (ODS) safety pilot system. The ODS
senses the amount of oxygen available in the room and
shuts the burner system off before the oxygen level
drops below 18%. The pilot can only be relit when fresh
air is available. This may require opening a window
or a door to another room or cracking the damper
open slightly.
Important: For safe operation and proper performance of this product and to comply with certifi cation, listings,
and building code acceptances, use ONLY Peterson Real-Fyre® controls, parts, and accessories
that have been specifi cally listed or certifi ed for use with this burner system. Use of other controls,
parts, or accessories is prohibited and will void all warranties, certifi cations, listings, and building
code approvals, and may cause property damage, personal injury, and loss of life.
This unit may not be installed in a vented fi replace with
a chimney of less than 15 feet in height.
Observing minimum fi replace dimensions and centering
the appliance in the fi replace will ensure adequate
clearance for operation and servicing. It may be
necessary to disconnect the unit for some types of
service.
DEPTH
HEIGHT
FR ONT
WIDTH OPENING
Rear
width
Height
Front
width opening
Depth
Minimum Permanent Chimney Vent Opening
in sq. in. (when used as a vented appliance)
Table 3-1
Factory
built
fi replaces
Masonry built
fi replaces
Chimney
Height
15'
15 23
20'
13 21
25'
11 -
30'
10 19
Any installation of this appliance is subject to minimum fi replace size requirements below:
Rev 8 - 1405271000
L-F2-057
This gas log set has been certifi ed to two standards:
UNVENTED ROOM HEATER-ANSI Z21.11.2
VENTED DECORATIVE APPLIANCE-ANSI Z21.60
Check local or state codes to determine if vent-free
heaters are permitted in your area before you install
this log set as a vent-free appliance. If not permitted,
you may install and operate this log set as a vented
appliance.