Owner`s manual

21
WOOD CHIP PLACEMENT
The designer wood chip provided with the 15(M)(P) and 01V(P) log sets is for aesthetics
and does not affect operation of the G10 Series vent-free gas log set. The wood chip
should be placed in front of the valve, with at least a
1
/
2
inch between it and the valve
(see Fig. 21-5 and Fig. 21-3).
Note: The wood chip may be HOT during and directly after operation of the gas log
set. Do not place the wood chip on or in the log set.
5
Fig. 21-4
REFRACTORY LOG PLACEMENT
Log placement is critical to ensure stability of the logs
and proper performance of the gas log set. Be sure to
follow log placement instructions carefully!
1. Each log in the vent-free gas log set is numbered
to aid in the log placement procedures. Set the
REAR log on the grate so that the rear of the main
burner bracket fi ts into the 2 locating grooves in
the front face of the log (see Fig. 21-1, No. 2).The
back of the FRONT log (Fig. 21-1, No. 1) fi ts tight
up to the front of the main burner bracket on the
grate (see Fig. 21-2).
2. Check that the logs are centered left to right.
3. Position the intermediate logs #3 and #4 on top of
the bottom logs. Locate the logs so that each log
rests in the corresponding slots on the bottom front
logs and bottom rear log (see Fig. 21-3).
4. Position the top log #5 on the top of the intermediate
logs. Locate the top log by placing it into the slots
of the intermediate logs (see Fig. 21-4).
After setting the logs into position, as described above,
ensure each is properly and fi rmly seated. The vent-
free gas log set will not function as intended if the logs
are not correctly positioned. When placed properly,
the fl ames will not strike any portion of logs #3, 4
or 5. Periodically check the positioning of all logs to
ensure proper log placement and stability. If any fl ame
is striking any of the logs, recheck log placement.
Adjust to conform with instructions. There should be
no fl ame impingement on these logs.
Maintain log position as shown AT ALL TIMES.
CHFR-16/18" LOG SET SHOWN
2
1
Fig. 21-1
3
4
Fig. 21-3
A
B
Fig. 21-2
A
Ensure back of FRONT log is
snug up to bracket
B
Ensure notches in face of
REAR log slide over rear
of bracket
CAUTION: BURN HAZARD. LOGS WILL REMAIN
HOT FOR SOME TIME AFTER USE.
YOU MUST MAINTAIN THE LOG LAYOUT AS SHOWN TO
ENSURE PROPER OPERATION OF THE LOG SET.
IF YOU NEED TO REPOSITION ANY LOG TO MAINTAIN THE PROPER
LAYOUT, USE HEAT RESISTANT GLOVES
OR ALLOW LOGS ADEQUATE TIME TO COOL BEFORE HANDLING.
INSTALLATION - LOG PLACEMENT
Fig. 21-5