Owner`s manual

SERVICING AND CLEANING (cont.)

Fig. 55-1 Unfasten rear panel

FAN ASSEMBLY CLEANING

The fan assembly MUST be cleaned annually to remove

lint, dust, and any debris / build up. It is mounted to the rear

of the insert.

Note: Removal of the insert ﬁ rst requires removal of the

screen and surround/eyebrow pieces.

1. Remove the insert from the ﬁ replace.

2. Remove the 4 securing hex screws and the rear panel

(fan assembly attached) using a

" nut driver or

equivalent. See Fig. 55-1.

3. Slightly lift the panel up, then pull the panel and fan

assembly out of the unit (see Fig. 55-2 and 55-3).

4. Vacuum the fan assembly, ensuring to remove all debris

/ build-up.

5. Re-install the fan assembly by ﬁ rst dropping in the bottom

of the panel, then lifting up into place (see Fig. 55-4).

Use the screws to re-fasten the panel.

6. Re-install the insert.

CAUTION: Ensure all interior components of the insert

(i.e. decorative media, panels) remain in

their proper position after re-installing the

insert (due to movement). Adjust if needed.

7. Be sure to properly re-install all appliance components.

FUEL CONVERSION KITS

A certiﬁ ed kit is available from the manufacturer to convert

your appliance from natural gas to L.P. or vice versa. Contact

your dealer for ordering information.

CK-31-NAT(25,30,36)-2 L.P. to Nat. Conversion Kit

CK-31-LP(25,30,36)-2 Nat. to L.P. Conversion Kit

Follow the instructions provided with the kit when converting.

Fig. 55-2 Lift panel for removal

Fig. 55-3 Remove panel / fan assembly & clean

Fig. 55-4 Re-install detail

only remove

indicated screws

Vacuum

entire fan

assembly

(rear of direct vent insert)