Owner`s manual

SERVICING AND CLEANING (cont.)

Fig. 54-1 Remove lintel

Fig. 54-3 Install new bulb

Fig. 54-4 Install plate and gaskets

Fig. 54-5 Install glass & fasten all screws

Fig. 54-2 Remove light assembly

LIGHT BULB REPLACEMENT

Reference the ANNUAL CLEAN/INSPECTION section for

details on accessing the light assembly, found on the top of

the ﬁ rebox interior.

Important: Only replace with 120V / 25 watt bulbs. Wear

gloves when handling the light bulb.

1. Remove the lintel found at the top front of the unit. Use

" nut driver to remove the two hex screws found on

each side of the lintel. See Fig. 54-1.

2. Using a Phillips screwdriver, unfasten the 4 screws that hold

the light assembly in place (see Fig. 54-2). Then remove

the glass, housing plate, and gaskets. Set aside the glass

and housing plate. Discard the old gaskets.

3. Wearing gloves, reach into the ﬁ xture, gently grab the bulb,

and pull it straight out.

4. Insert the new 120V / 25 watt bulb into the socket so that

both pins slide all the way in (see Fig. 54-3).

5. Place two new gaskets on the plate housing, feed one

screw through a pilot hole, and align the assembly up into

the light assembly. Partially tighten. See Fig. 54-4.

6. Hand tighten the right screw, then insert the glass in

between the two gaskets (see Fig. 54-5).

7. Once the glass, housing plate, and gaskets are properly

in place, completely tighten all 4 screws.

CAUTION: Ensure the light assembly is properly in place

and fully tightened. Failure to do so will result

in combustion fumes escaping the interior

ﬁ rebox.

8. Re-install the lintel, and all other components.

Unscrew