Owner`s manual

53
SERVICING AND CLEANING (cont.)
PRG
ON REMOTE OFF
Fig. 53-3 Remove switch and plate
for battery access
Remote
receiver
PRG
ON REMOTE OFF
Fig. 53-2 Receiver location (left side, control box)
(Surround,
left panel)
(Direct
vent
insert)
Fig. 53-1 Transmitter battery replacement
B
A
Remove lid
for battery
access
Fig. 53-4 Receiver battery replacement
(PRG key)
Move to ON
position, then
remove
Unscrew,
then remove
plate
Battery lid
BATTERY REPLACEMENT
Ensure all control/remote system components are in the
OFF position prior to any battery replacements.
Note: Remote system syncing may be required after any
battery replacements. See section below if needed.
Remote transmitter:
The remote transmitter requires 3 AAA batteries to operate.
Locate the transmitter, remove the lid (found on rear), and
properly insert new batteries as marked. Re-secure the lid.
See Fig. 53-1.
Remote receiver:
The remote receiver requires 4 AA batteries to operate.
Turn off gas to the unit. Locate the receiver on the control
box, which is located on the left side of the unit (see Fig.
53-2).
Note: Access to the receiver requires removal of the screen
and surround/eyebrow pieces.
Slide the 3-position switch on the receiver to the ON position,
then remove the switch. Unfasten the plastic plate using a
Phillips screwdriver. See Fig. 53-3. Remove the battery lid
(push in tabs) and properly insert new batteries as marked
(see Fig. 53-4). Re-secure the lid, the plate, and the switch.
Be sure to properly re-install all appliance components.
SYNCHRONIZE REMOTE SYSTEM
The remote system is synchronized at the manufacturer.
However, should the remote transmitter and receiver require
to be synced, follow the procedure below.
1. Locate the receiver on the control box, which is located
on the left side of the unit (see Fig. 53-2).
Note: Access to the receiver requires removal of the
screen and surround/eyebrow pieces.
2. Slide the 3-position switch on the receiver to the REMOTE
position.
3. Locate the PRG key on the receiver (reference Fig.
53-3). Use the tip of a pen or a wire clip to push the
PRG button. The receiver will beep 3 times indicating
that it is ready to synchronize with the remote transmitter.
4. Push the ON/OFF key on the remote transmitter. The
receiver will beep 4 times to indicate that the transmitter's
command is accepted and set to the particular code of
the transmitter. The system is now initialized.
5. Be sure to properly re-install all appliance components.