Owner`s manual

SERVICING AND CLEANING (cont.)

2. An air shutter is located beneath each burner. Reference

the ANNUAL CLEAN/INSPECTION section for details on

accessing the front/rear burner. Rear burner shown here.

3. Remove the ember screen (if applicable) and left and right

ﬂ oor panels. See ﬁ gure on previous page, "A" and "B".

4. Remove the grate. Then remove the 2 hex screws found

on the ends of the rear burner using a

" nut driver.

See Fig. 52-1, "C" and "D".

5. Remove burner by sliding it to the right, so that the venturi

tube clears the oriﬁ ce, then fully out. See Fig. 52-2, "E".

Note: When removing a burner with a wire adjustment

handle, be sure the handle comes out with the burner.

6. Use a

" nut driver to loosen the air shutter screw, and

adjust as needed. Be certain to re-tighten the screw when

done. See Fig. 52-3.

More air will result in shorter ﬂ ames and less color, less

air will result in bigger ﬂ ames and more color.

Note: Make adjustments in

" increments. Very small

changes result in major changes in ﬂ ame appearance.

Note: Do not completely tighten the screw on burners

equipped with a wire adjustment handle, as doing so

will prevent the wire handle from functioning.

7. Repeat this process for the front burner, if applicable/

required. Then properly replace the burner(s).

Note: When replacing a burner with a wire adjustment

handle, you will need to ﬁ rst place the wire into the

hole found on the bottom front of the unit, then rotate

the burner into place (see Fig. 52-4).

8. Ignite the burner and observe the ﬂ ames. If required, repeat

the adjustment process until the proper ﬂ ame is achieved.

9. Be sure to properly re-install all appliance components.

Fig. 52-2 Remove burner

Fig. 52-3 Adjust air shutter

Fig. 52-1 Remove grate & burner hex screws

Adjust as

needed

(Loosen screw)

Fig. 52-4 Replace burner & wire handle (select burners)

Fig. 52-5 Proper ﬂ ame appearance