Owner`s manual

49
SERVICING AND CLEANING
The appliance, the fi replace, and the installation must be inspected annually. The appliance requires annual
maintenance by a qualifi ed professional service technician. Refer to these instructions for details. Performing these
procedures will ensure proper operation, appearance, and safety.
WARNING: Turn off the gas and electrical power (when instructed) to the fi replace and allow it to completely cool prior
to servicing or cleaning of the appliance.
CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous
operation.
Au moment de l’entretien des commandes, étiquetez tous les fi ls avant de les débrancher. Des erreurs de
câblage peuvent entraîner un fonctionnement inadéquat et dangereux.
• Wear appropriate gloves and safety glasses during any servicing or cleaning. When handling the surround and
screen components, and glass panel, be sure to wear clean non-marking gloves to ensure a clean fi nish and avoid
any fi ngerprints.
• DO NOT use substitute materials when replacing any components of the appliance.
• Verify proper operation after servicing.
S’assurer que l’appareil fonctionne adéquatement une fois l’entretien terminé.
• DO NOT clean when hot.
ANNUAL CLEAN / INSPECTION
The following should only be performed annually by a qualifi ed professional service technician:
1. When the unit is cool, remove the screen and surround/eyebrow pieces from the appliance (wear gloves). Be sure
to fi rst disconnect the ON/OFF switch located on the left side-panel of the surround.
2. Remove the glass panel (wear gloves). Inspect it thoroughly for any damage to the glass, gasket, or overall assembly.
Replace if necessary. Clean the glass to remove any build-up (which is a by-product of combustion). Reference the
GLASS PANEL REMOVAL AND MAINTENANCE section for details .
3. Carefully remove the logs and glowing embers. Use latex gloves and handle with care! Inspect the logs. Chalking
on the logs is normal. If excessive soot is present, reference the AIR SHUTTER ADJUSTMENT section, and ensure
proper log placement when replacing. Do Not attempt to brush or vacuum the logs.
Store on a soft surface and in a safe location for future reinstallation.
4. Inspect the burner and pilot assembly for any debris/blockages. Vacuum the fi rebox fl oor of the appliance, then use
a compressed air duster (commonly available at a offi ce supply store) to blow through all of the burner ports and the
pilot assembly area.
5. Remove the insert from the fi replace and remove the rear panel (fan assembly attached). Vacuum the fan assembly.
See the FAN ASSEMBLY CLEANING section for details. Re-install fan assembly and insert.
6. Check that the control box (left side of unit) and all appliance openings are clean and clear of any debris/blockages.
The fl ow of combustion and ventilation air must not be obstructed.
7. Inspect the condition of any wiring for melting or damage. Refer to the wiring diagram in the SPECIFICATIONS AND
DIMENSIONS section of this manual for overall orientation.
8. Check that the area around the appliance is kept clear and free from combustible materials, gasoline, and other
fl ammable vapors and liquids.
9. Examine the entire vent system and termination for signs of blockage, obstruction, or dislocation of vent components.
Reference the INSTALLATION section for re-installation details if required.
10. Carefully replace the logs, embers , glass panel, screen, and surround/eyebrow pieces as instructed in the INSTALLATION
section of this manual.
Remove embers and logs
Inspect logs for excessive soot
D1-30
shown
Fig. 49-1 Annual clean / inspection fi rebox overview
Remove screen and surround/eyebrow pieces
Remove glass panel
Inspect and clean
Inspect burner and pilot area
Vacuum fi rebox fl oor
Blow out ports with compressed air duster
Inspect controls, openings,
wiring, and vent system
Remove
rear panel &
vacuum fan
assembly