Owner`s manual

37
PRG
ON REMOTE OFF
LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these
instructions exactly, a fire
or explosion may result
causing property damage,
personal injury or loss of life.
A. This appliance is equipped with an ignition device that automatically lights the pilot. DO NOT attempt to
light the pilot by hand.
B. BEFORE OPERATING, smell all around the appliance area for gas. Be sure to smell next to the fl oor
because some gas is heavier than air and will settle on the fl oor.
WHAT TO DO IF YOU SMELL GAS
• Do not light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
If you cannot reach your gas supplier, call the fi re department.
C. Use only the supplied standing pilot toggle switch or the control/remote system components to light the
pilot. This valve will not operate if the pilot is not lit and stable.
D. Do not use this appliance if any part has been under water. Immediately call a qualifi ed service technician
to inspect the appliance and to replace any part of the control system and any gas control which has been
under water. Attempted operation may result in fi re or explosion resulting in property damage, personal
injury or loss of life.
Fig. 37-2
Standing pilot
toggle switch
INTERMITTENT PILOT MODE AND STANDING
PILOT MODE
This appliance is equipped with an electronic ignition system
that fi rst lights a pilot then uses the pilot to ignite the main
burners. By default, the pilot is in "Intermittent Pilot" mode,
and will only light and remain on while the main burners
are operating. The pilot can be set to the "Standing Pilot"
mode, allowing the pilot to remain on indefi nitely.
Note: Access to the standing pilot toggle switch requires
removal of the surround. The switch is located on
the control box. (The control box is on the left side
of the unit.)
Intermittent Pilot Mode: This default mode turns the pilot
light off when the appliance is not functioning and only lights
the pilot automatically when the main burners are turned on.
Standing Pilot Mode: If the standing pilot switch is toggled
on, the pilot will ignite and remain on as long as the switch
is in the ON position.
Note: It is recommended that the "Standing Pilot" mode
be used during the winter months when external
temperatures fall below 50°F.
ON
OFF
Fig. 37-1 Control box (left side, behind surround)
(Surround,
left panel)
Standing
pilot toggle
switch
(Direct
vent
insert)
Initial operation will produce an odor and some smoke due
to lubricants used in the manufacturing process. This is
normal and will cease after at least 30 minutes of operation.
Keep the house well ventilated during this process.
WARNING: The glass panel and other surfaces of this
appliance get extremely HOT and can cause
burns if touched. Carefully read, understand, and
follow the lighting and operation instructions,
and use caution at all times.